User Manual

Glue together wing root sheeting material TT-31
and TT-23, then glue to first rib bay.
9
TT-31
TT-32
10
Remove wing from building board. Please handle with care and always place on an even surface, as the wing has no tortional stability at this
time.
Glue bottom sheeting material to ribs. For best results use thin CA. Also glue in place sheeting material to the underside of wing root.
Place wing on building board and glue false
leading edge TT-33 (balsa, 2 x 8 mm) to ribs and
bottom sheeting. Sand flush with top of ribs after
glue has dried.
11
TT-33
Glue in place top sheeting TT-01 on ribs, spar and false leading
edge. Use suitable weights and tape to secure sheeting material
until glue has dried completely.
Cut off sheeting material flush with false leading edge then
carefully sand sheeting material flush with false
leading edge. Use a long sanding bar for best
results.
12
TT-01
Glue leading edge TT-34 (balsa, 3 x 8 mm)
to false leading eding edge and sand to
shape after glue has dried.
13
TT-34