User Manual

32
33
Fit wing into wing saddle and align with centre of fuselage.
Through bore in former R2 mark position of wing dowel, then
drill with 4 mm.
Insert wing dowel F32 in wing and slide wing in place on
fuselage. Make sure wing and dowel fit perfectly and without
binding.
Correct, if necessary, then glue dowel in place.
Position wing on fuselage and align with centre line.
12 mm from the rear of the wing drill with 4 mm through centre
of wing and into R18/R19. Drill through R18/R19 with 5 mm and
from below epoxy in place retaining nut R31.
34
35
Fit canopy former R32 in place in fuselage. To achieve best
results, bevel off contact surfaces with upper sheeting,
triangular stock and canopy frame.
From behind glue magnet R33 and retainer R34 to former
(epoxy), then glue former R32 in place and secure with clamps.
Fit canopy former R35 in place in rear end of canopy. To achieve best results
bevel off contact surfaces with upper sheeting and triangular stock.
From behind glue magnet R33 and retainer R34 to former (epoxy), then glue
former R35 in place and secure with clamps.
Attention: Make sure you check polarity of magnets before you glue!
At front end of canopy glue in place former R36 and retaining tab R37 and
secure with clamps.
Note: Fuselage turned upside
down for clarity.
i
F32
R31
R32
R35
R36
R37
R33
R33
R34
R34