Instructions / Assembly

ManualsBrandsAero Pure ManualsBathLow Profile 110 CFM Satin Nickel 0.9 Sones Quiet Ceiling Bathroom Ventilation Fan with LED Light/Night Light

BATH FAN

READ AND SAVE THESE INSTRUCTIONS

Thank you very much for purchasing our bath fan.

Please read the instructions carefully before attempting

to install, operate, or service our bath fan. Failure to comply

with instructions could result in personal injury or property

damage. Please retain this booklet for future reference.

INSTALLATION INSTRUCTIONS

...............................................................................................................

.......................................................................................

...........................................................................................................

.........................................................................

.............................................................................................................

....................................................................................................

..............................................................

..................................................................................

....................................................................................

...................................................................

......................................................................................................

.................................................................................................

TABLE OF CONTENTS

UNPACKING

SUPPLIED ACCESSORIES

DESCRIPTION

GENERAL SAFETY INFORMATION

DIMENSIONS

WIRING DIAGRAM

INSTALLATION （NEW CONSTRUCTION)

INSTALLATION （RETROFIT）

MAINTENANCE (CLEANING)

PRACTICAL GUIDE TO INSTALLATION

SPECIFICATIONS

PRODUCT SERVICE

Ⅰ

Ⅱ

Model No.

ABF80G15 Series

ABF110G15 Series

ABF80L5 Series

ABF110L5 Series

ABF80G16 Series

ABF110G16 Series

ABF80L6 Series

ABF110L6 Series

Summary of content (11 pages)

PAGE 1
BATH FAN INSTALLATION INSTRUCTIONS Model No. ABF80G15 Series ABF110G15 Series ABF80G16 Series ABF110G16 Series ABF80L5 Series ABF110L5 Series ABF80L6 Series ABF110L6 Series READ AND SAVE THESE INSTRUCTIONS Thank you very much for purchasing our bath fan. Please read the instructions carefully before attempting to install, operate, or service our bath fan. Failure to comply with instructions could result in personal injury or property damage. Please retain this booklet for future reference.
PAGE 2
UNPACKING Unpack and carefully remove the unit from carton. Refer to the supplied accessories list to verify that all parts are present. SUPPLIED ACCESSORIES Grille or G15 or G16 or L5 L6 Suspension bracket assembly 1 Long screw (ST4X30) 5 Wire Protector Nut 1 Installation instructions 1 DESCRIPTION These bath fan models are listed by ETL under ETL file No.5011292. These bath fan models use a Sirocco fan driven by a capacitor motor.
PAGE 3
GENERAL SAFETY INFORMATION 1. Do not install this bath fan where interior room temperature may exceed 104°F (40°C). 2. Make sure that the electric service supply voltage is AC 120V, 60Hz. 3. Follow all local electrical and safety codes, as well as the National Electrical Code (NEC), and the Occupation Safety and Health Act (OSHA). 4. Always disconnect the power source before working on or near the fan, motor, light fixture, or junction box. 5.
PAGE 4
DIMENSIONS Series: ABF80L6, ABF110L6 ③ Unit: inches (mm) 5 4/5 (147) ⑩ ⑦ 4 7/8 (123) 3 7/8 (98) 10 2/5 (265) 3 4/5 (97) ② 10 1/4 (260) ① ⑧ 12 1/8 (308) ⑤ ⑥ 7 1/3 (186) ④ ⑨ Blade Grille Adaptor Damper Fan body 6 7 8 9 10 Knock-out plate Junction box Capacitance box Bracket assembly LED light 3/5 (14.
PAGE 5
INSTALLATION I（NEW CONSTRUCTION）！ CAUTION: Please wear gloves during the installation work. IMPORTANT: Remove the tape from damper and adaptor before installation. As shown below: 4 screws (ST4x30) Joist situation: Fig.1 L Two cases of spacing L : A 12 inches (305 mm) B 16~24 inches (406~610 mm) A B If the spacing L is 12 inches (305 mm) on joists, please follow the installation step as (Fig.1). Secure 4 screws (ST4X30) at flange of frame to the joists.
PAGE 6
INSTALLATION I（NEW CONSTRUCTION）CONTINUED Buckle 5.Push the fan body upwards until the fan body is stopped by the buckle on the adapter and secure the fan body by using the remaining 3 self-drilling screws (ST4X30). (Fig.5) ！ CAUTION: Hold the fan body to prevent falling before fixing the screws. Fan body 3 Screws (ST4x30) Fig.5 6.Install a circular duct and secure it with clamps or ties and seal it with mastic or approved duct tape.
PAGE 7
INSTALLATION I（NEW CONSTRUCTION）CONTINUED 8. Finsh ceiling work. Align ceiling hole with the inside edges of the flange. (Fig.8) 2/5 Unit: inches (mm) (26 5) 10 2/5 (26 5) 10 IMPORTANT: After finishing the celling work, fill gap between flange and celling with caulk or other sealant to prevent air leakage. Caulk Celling Fig.8 9. Insert mounting springs into slots and mount grille to fan body. (Fig.
PAGE 8
INSTALLATION II（RETROFIT） 1. Put the folded bracket assembly into ceiling hole, then follow step 3-4 of Installation I (NEW CONSTRUCTION page 5) to complete the extra spacebracket installation. (Fig.12) Unit: inches (mm) A 10 3/5 (27 0) (270) 10 3/5 B screws (ST4x20) Fig.12 2. Install a circular duct and secure with clamps or ties and seal with mastic or approved foil tape. A 4＂, 5＂, or 6＂circular duct is needed to connect to relevant part of adaptor. (Fig.
PAGE 9
INSTALLATION II (RETROFIT) CONTINUED 4. Push the fan body upwards until the fan body is secure with the joint, and secure them by using the remaining 3 self-drilling screws(ST4X30) (Fig.15) 5. Follow step 10 of Installation I (NEW CONSTRUCTION page 7-8) to complete installation. 3 Screws (ST4x30) Fig.15 MAINTENANCE (CLEANING) WARNING: Disconnect power source before working on unit. Routine maintenance must be done every year. CAUTION: 1.
PAGE 10
MAINTENANCE (CLEANING) CONTINUED 4. Remove dust and dirt from fan body using a vacuum cleaner. (Fig.18) Fig.18 5. Using a cloth dampened with kitchen detergent, remove any dirt from fan body then wipe dry with clean cloth. (Fig.19) 6. Reinstall Grille. Fig.19 PRACTICAL GUIDE TO INSTALLATION Properly insulate the area around the fan to minimize building heat loss and gain. (Fig.
PAGE 11
SPECIFICATIONS Model No. Duct Air Voltage Frequency Noise diameter direction (V) (Hz) (sones) (inches) Power consumption (W) Fan Light N.Light Air volume Speed at 0.1"WG (rpm) (CFM) ABF80G15OR ABF80G15SN Exhaust 120 60 4′′, 5′′, 6′′ 0.4 18.7 849 80 Exhaust 120 60 4′′, 5′′, 6′′ 0.4 18.7 849 80 ABF110G15SN Exhaust 120 60 4′′, 5′′, 6′′ 1.1 25.2 1140 110 120 60 4′′, 5′′, 6′′ 1.1 25.2 1140 110 Exhaust 120 60 4′′, 5′′, 6′′ 0.3 18.4 10 0.