How to Guide

Aero Pure Wiring Diagrams DH G & L Series

BATH FAN

ADDITIONAL WIRING DIAGRAMS

Model No.

ABF110DHG5 Series

ABF110DHG6 Series

ABF110DHL1 Series

ABF110DHL5 Series

ABF110DHL6 Series

ABF110DCMH-S G5

ABF110DCMH-S G6

ABF110DH G5, ABF110DH G6, ABF110DCMH-S G5, ABF110DCMH-S G6

(2 Switches required)

- Be sure to turn OFF the power at the breaker before installing to avoid electrical shock or injury.

- The primary switch is what is bringing power into the unit. See DIAGRAM A for switch requirement.

-The secondary switch is the On/Off switch that is connected to the wires marked Red/Signal on

DIAGRAM A.

- Be sure that the secondary switch is a traditional On/Off switch and does not contain a Neutral hookup.

A Ground (Green wire) is fine. Typically, there will be two brass screws on one side and a green screw on

the other side of the switch. See DIAGRAM A for more information.

- Make sure both the primary switch (the switch that feeds power into the unit directly) and the secondary

switch (Red/Signal wires) are in the OFF position while you are wiring the unit.

- Once the unit, and both switches are properly wired, per the instructions and diagrams provided, turn

the power ON at the breaker, then turn ON the primary switch (the switch feeding power into the fan) and

leave the secondary switch OFF (the switch connected to the red wires coming out of the unit). Be sure to

turn the Low Airflow knob located at the back of the unit to “0 before turning on the primary switch”.

- With the grille cover removed from the fan, place a small cup of hot steaming water underneath the fan

humidity sensor that is located to the left of the motor. The humidity sensor has a USB plug attached to it.

Be sure the USB is plugged in.

- With the primary switch on, and the secondary switch off, the hot steaming water underneath the

humidity sensor will turn the fan on.

- If the fan does not turn on, rotate the Low Airflow knob from 0 to 100 and back again to 0 to reset the

unit. Also, rotate the humidity knob, located on the sensor to 60 or in the middle of the 30 and 80 markers

FAN WITH HUMIDITY SENSOR ONLY

PAGE 1
BATH FAN ADDITIONAL WIRING DIAGRAMS Model No. ABF110DHG5 Series ABF110DHG6 Series ABF110DHL1 Series ABF110DHL5 Series ABF110DHL6 Series ABF110DCMH-S G5 ABF110DCMH-S G6 FAN WITH HUMIDITY SENSOR ONLY ABF110DH G5, ABF110DH G6, ABF110DCMH-S G5, ABF110DCMH-S G6 (2 Switches required) - Be sure to turn OFF the power at the breaker before installing to avoid electrical shock or injury. - The primary switch is what is bringing power into the unit. See DIAGRAM A for switch requirement.
PAGE 2
FAN WITH HUMIDITY SENSOR ONLY CONTINUED .- Place steaming hot water back under humidity sensor and wait for the fan to turn on. If the fan does not start, double check that the secondary switch is in the OFF position and the USB is plugged in and repeat previous step. - Once the fan starts with the humidity of the water, remove water and allow fan to turn off on its own, which will ensure the sensor is working properly.
PAGE 3
WIRING DIAGRAM Fan only model: Fan body Junction box Motor DIAGRAM A Neutral White P C B Red Yellowgreen Red Black Live Green Earth ground Power switch Income Hot (Black wire) Ground Yellow screw FAN SENSOR Yellow screw Green screw Fan Hot (Black wire) With light model: Fan body Junction box White Motor P C B Yellowgreen Light Body Neutral Red Red Black Live Green Earth ground Brown Live (Light) White Neutral Blue Live(N.