Instructions / Assembly

WIRING DIAGRAM
FEATURE
Fan only model:
With light model:
Motor
Earth ground
Live
Neutral
Green
Black
White
P
C
B
Yellow-
green
Red
Red
Signal
Signal
Power switch
Control switch
Fan body
Junction box
Motor
Earth ground
Live
Neutral
Green
Black
White
P
C
B
Light Body
Blue
Brown
White
Live (Light)
Live(N. Light)
Neutral
Yellow-
green
Red
Red
Signal
Signal
Power switch
Control switch
Fan body Junction box
All fans come with Flow-Selection speed switch, Multi-Speed switch,
Time Delay switch and Air Trimming switch.
●Flow-Selection. The switch with choosing option 50-80-110CFM is
set on the PCB box and is default high speed.
●Multi-Speed. The switch allows the fan to run at the lower speeds
continuously to meet Indoor Air Quality. As an example, when
Flow-Selection setting is 80CFM, Multi-Speed can be chosen 0, 50,
60, or 70CFM as a low speed.
●Time Delay. The switch is for time delay setting. Setting range is 0,
5, 10, 20, 30, 45 or 60 minutes.
●Air Trimming switch. The switch is for micro-adjusting the air volume
when the actual airflow is lower than set.
0
50
60
70
80
90
100
0
5
10
20
30
45
60
Time(min)
50
80 110
L
H
Air Trimming
Air Volume(CFM)
Time delay
Air trimming
Flow-Selection
Multi-Speed
5
INSTRUCTIONS:
Firstly, the power switch should be turned on.
①When the control switch is turned on, the fan runs at high speed continuously only. The sensors will
not work and Time delay switch does not apply to this mode.
②When the control switch is turned off, the fan runs at chosen low speed on Multi-Speed switch
continuously, and boosts in high speed when the sensor detects. The fan runs at high speed for
amount of time that selected from the Time Delay switch before returning to low speed when the
sensor stops detection.