Owner's Manual

Model: AP120H-S Series
6” Duct
Static Pressure (inches w.g.)
0.1
0.25
Air Volume (CFM)
126
111
Noise (sones)
0.7
n/a
Power Consumption (Watts)
33
32.3
Energy Efficiency (CFM/Watts)
3.8
3.4
Current (AMPS)
0.28
0.27
ENERGY STAR rated
Yes
Grille Dimensions
13 3/8’ x 13 3/8”
Model
Qty
Comments
Project
Location
Architect
Engineer
Contractor
Submitted by
Date
Specifications
AP120H-S SERIES
Slim Fit Bathroom Fan with Integrated Humidity
Sensor
ETL Listed for installation over tub/shower enclosure with
GFCI circuit wiring.
Description: Quiet slim fit bathroom fan engineered for continuous
run  Ceiling or wall mount  Integrated user adjustable humidity
sensor  Suitable for new construction or remodeling  HVI certified
 ENERGY STAR qualified  ETL listed for use in insulated ceilings
(Type I.C.).
Motor/Blower: Permanently lubricated enclosed condenser motor
engineered for continuous energy efficient operation; power rating
120v/60Hz; motor equipped with thermal shut off.
Housing: Rugged 26 GA galvanized steel; 2 anti-vibration hangar
bar brackets adjustable to 24” span included; designed for ceilings
with a minimum of 6” clearance.
Duct: Detachable 4” and 6” duct connector with built in back draft
dampener.
Grille: Contemporary design; low maintenance, wipe clean UV
inhibiting polymeric resin; attaches to housing with torsion springs.
Finishes: White (W); Satin Nickel (SN); Oil Rubbed Bronze (OR).
Installation: Must be installed by a licensed professional.
Complete installation instructions included.
User-Adjustable Integrated Sensor: Humidity sensor adjustable
from 50-100% relative humidity (RH); responds to a.) rapid to
moderate rise in humidity or b.) .humidity above preset RH set point.
Warranty: 6 Years
Architect’s Specifications: Ventilation fan will be ceiling or wall
mount, ENERGY STAR qualified and no more than 0.7 sones at 120
CFM as certified by HVI at 0.1 Ps (inches water gauge). Power
consumption shall be no greater than 33 watts and ENERGY STAR
rated with an efficiency rating of no less than 3.8 CFM/watt. Fan will
begin operation when humidity rises above user adjustable setpoint
(50-100% RH). The motor will be permanently lubricated,
engineered for continuous operation. Duct diameter will be 6” round.
Fan shall be ETL/cETL listed for tub/shower enclosure when used
with GFCI branch circuit wiring and shall be ETL/cETL listed for
use in insulated ceiling (Type I.C.). Fan shall be ASHRAE 62.2,
LEED, CalGreen, and WA Ventilation Code compliant.
Aero Pure, LLC  1006 Bankton Circle Ste B  Hanahan, SC 29410  843.377.8642
www.aer opur e fa ns.c o m