Installation Instructions

Figure 5

Figure 4

d) Lower the sintered diffuser into

the hot tub and allow it to rest

on the bottom.

e) If the hot tub has a hard cover,

align the ozone tube with the

center seam of the cover and

allow it to lie in the gap to

ensure that it is not pinched

when the cover is closed (see

figure 4).

f) Locate the closest electrical

outlet on the house or garage

that is at least 10’ from the hot

tub that can be used to supply

power to the equipment (Figure

3) Grounding Instructions:

a) This product must be grounded. In the event of an electrical

short circuit, grounding reduces the risk of electric shock by

providing an escape wire for the electric current. This product

is equipped with a cord having a grounding wire with an

appropriate grounding plug (type 5-15P).

The plug must be plugged into an outlet

(type 5-15R) that is properly installed and

grounded in accordance with all local codes

and ordinances. DANGER – Improper

installation of the grounding plug can result

in a risk of electric shock. If repair or

replacement of the cord or plug is

necessary, do not connect the grounding

wire to either flat blade terminal. The

wire with insulation having an outer

surface that is green with or without

yellow stripes is the grounding wire.

Check with a qualified electrician or

serviceman if the grounding

instructions are not completely

understood, or if in doubt as to whether

the product is properly grounded.

Figure 6