Use and Care Manual

Figure 7

Power cord to Aero-

Spa™ equipment

the product is properly grounded.

b) Do not modify the plug provided; if it will not fit the outlet,

have the proper outlet installed by a qualified electrician. This

product is for use on a nominal 120-volt circuit and has a

grounding plug that looks like the plug illustrated (type 5-15P)

in Figure 6. Make sure that the product is connected to an

outlet (type 5-15R) having the same configuration as the plug.

No adapter should be used with this product. This product

has an automatically reset thermal limiter, which shuts off the

entire product when an elevated temperature condition exists.

When the product cools it will automatically restart.

c) Only if required, obtain a UL outdoor rated extension cord

Never locate the Aero-Spa™ generator closer than 10’ from

the hot tub.

d) Insert the electrical plug from the Aero-Spa™ into the

extension cord.

e) Insert the GFCI & Surge Protector Plug (Figure 7) into the

electrical outlet identified in step 3) Figure 5.

f) Insert the cycle timer cord into the GFCI breaker identified in

(Figure 7).

g) Insert the 120 VAC power cord or the extension cord

identified in 3) above into the cycle timer

4) Turning Product On

a) Press the “reset” button (Figure 7). The equipment will be

turned “on” and

will be running.

Occasionally

GFCI breakers

will experience

nuisance

tripping. This will

shut off the

power to the

equipment. If

this occurs,

press the “reset”

button. If

Reset

Button