Specifications

5
4. As shown in Figure 4 put one of the black 4” carriage bolts
#8 through the siderail #7, bracket #9 (make sure the foam
on the back of bracket #9 is facing up) and through the frame.
When the bolt is all the way through the frame install a 1” fender
washer #10 and a kep nut #2. Use this procedure to install the
other siderail and then tighten both siderails.
5. Standing in front of the treadmill (as shown in figure 5) Figure 2
pick up the motor cover so that it is level and the word
PaceMaster is upside down. Holding the motor cover
level and waist high tilt it 45 degrees by lowering your
left hand. Now slide it between the handlebar and rotate
the motor cover so that it is level by raising your left hand.
Lower the cover all the way making sure you keep it level.
Install the three #8x1/2” black sheet metal screws into the
front of the motor cover. Press down on each side of the
motor cover where it meets the gray plastic shrouds to
lock the Velcro pads in place.
CAUTION: Do not raise or lower motor cover without
it being level.
Figure 3
Figure 4
Figure 5
Testing Your Treadmill
• Your treadmill is completely adjusted and tested at the factory. However, due to changes occurring during shipment it should be tested. Once you
have assembled your treadmill and it is located where it will be used, proceed as follows (do not make any adjustments unless necessary).
CAUTION: When performing these tests DO NOT stand on the treadbelt. Once tested, always start and finish on the treadbelt.