User's Manual

5
55
5/
//
/8/2007
8/20078/2007
8/2007 15
1515
15
Table
Table Table
Table 4
44
4 –
––
– Timing Parameters
Timing Parameters Timing Parameters
Timing Parameters
3.3.3
3.3.33.3.3
3.3.3 Maximum Overall System Throughput
Maximum Overall System ThroughputMaximum Overall System Throughput
Maximum Overall System Throughput
When configured as shown in the table below, an AC4424 transceiver is capable
capable capable
capable of achieving
the listed throughput. However, in the presence of interference or at longer ranges, the
transceiver may not be able to meet these specified throughputs.
Table
Table Table
Table 5
55
5 –
––
– Maximum Overall System Throughputs
Maximum Overall System Throughputs Maximum Overall System Throughputs
Maximum Overall System Throughputs
RF Mode
RF ModeRF Mode
RF Mode Interface Ba
Interface BaInterface Ba
Interface Baud
ud ud
ud
Rate
RateRate
Rate
Duplex
DuplexDuplex
Duplex Direction
DirectionDirection
Direction Throughput
Throughput Throughput
Throughput
(bps)
(bps)(bps)
(bps)
Acknowledge 115,200 Half One way 80k
Acknowledge 115,200 Full Both ways 40k
4.
4.4.
4. Configuring the AC4424
Configuring the AC4424Configuring the AC4424
Configuring the AC4424
4.1
4.14.1
4.1 EEPROM P
EEPROM PEEPROM P
EEPROM PARAMETERS
ARAMETERSARAMETERS
ARAMETERS
A Host can program various parameters that are stored in EEPROM and become active after a
power-on reset. Table 6
Table 6 Table 6
Table 6 -
--
- EEPROM Parameters
EEPROM Parameters EEPROM Parameters
EEPROM Parameters, gives the locations and descriptions of the
parameters that can be read or written by a Host. Factory default values are also shown. Do
Do Do
Do
not write to any EEPROM addresses other than those listed below. Do not co
not write to any EEPROM addresses other than those listed below. Do not conot write to any EEPROM addresses other than those listed below. Do not co
not write to any EEPROM addresses other than those listed below. Do not copy a
py a py a
py a
transceiver’s EEPROM data to another transceiver. Doing so may cause the transceiver to
transceiver’s EEPROM data to another transceiver. Doing so may cause the transceiver to transceiver’s EEPROM data to another transceiver. Doing so may cause the transceiver to
transceiver’s EEPROM data to another transceiver. Doing so may cause the transceiver to
malfunction.
malfunction.malfunction.
malfunction.
Parameter
ParameterParameter
Parameter Typical Time (ms)
Typical Time (ms)Typical Time (ms)
Typical Time (ms)
Hop Time 1
Hop Period 8