User's Manual

5
55
5/
//
/8/2007
8/20078/2007
8/2007 17
1717
17
0 = Use Destination Address
1 = Automatically set Destination
to Server
Bit 3 – AeroComm Use Only
AeroComm Use OnlyAeroComm Use Only
AeroComm Use Only
Bit 2 – RTS Enable
0 = RTS Ignored
1 = Transceiver obeys RTS
Bit 1 – Duplex Mode
0 = Half Duplex
1 = Full Duplex
Bit 0 – Auto Config
0 = Use EEPROM values
1 = Auto Configure Values
Parameter
ParameterParameter
Parameter
EEPROM
EEPROM EEPROM
EEPROM
Address
AddressAddress
Address
Length
Len
g
th Len
g
th
Length
(Bytes
(Bytes(Bytes
(Bytes
)
))
) Range
RangeRange
Range Default
DefaultDefault
Default Description
DescriptionDescription
Description
Transmit
Retries
4CH 1 01 - FFh 10h Maximum number of times a packet is
sent out when Addressed packets are
selected.
Broadcast
Attempts
4DH 1 01 – FFh 04h Maximum number of times a packet is
sent out when Broadcast packets are
selected.
API Control 56H 1 01000011
b = 43h
Settings are:
Bit 7 – AeroCo
AeroCoAeroCo
AeroComm Use Only
mm Use Onlymm Use Only
mm Use Only
Bit 6 – RF Architecture
0 = Server-Client
1 = Peer-to-Peer
Bit 5 – AeroComm Use Only
AeroComm Use OnlyAeroComm Use Only
AeroComm Use Only
Bit 4 – Auto Destination
0 = Use Destination Address
1 = Automatically set Destination
to Server
Bit 3 – AeroComm Use Only
AeroComm Use OnlyAeroComm Use Only
AeroComm Use Only
Bit 2 – RTS Enable
0 = RTS Ignored
1 = Transceiver obeys RTS
Bit 1 – Duplex Mode
0 = Half Duplex
1 = Full Duplex
Bit 0 – Auto Config
0 = Use EEPROM values
1 = Auto Configure Values
Interface
Timeout
58H 1 01 – FFh F0h Specifies a byte gap timeout, used in
conjunction with RF Packet Size to
determine when a packet coming over
the interface is complete (160 us per