User's Manual

/8/2007

8/20078/2007

8/2007

DOCUMENT I

DOCUMENT IDOCUMENT I

DOCUMENT INFORMATION

NFORMATIONNFORMATION

NFORMATION

Revision

RevisionRevision

Revision

Description

DescriptionDescription

Description

Version 1.0 11/7/2001 – Initial Release Version

Version 1.1 10/14/2002 – Not Released

Version 1.2 10/18/2002 – Full release of AC4424 specification

Version 1.3 11/19/2002 – Made Full-Duplex incompatible with Stream Mode

Version 1.4 12/09/2002 – Changed Sub Hop Adjust setting recommendations

Version 1.5 1/30/2003 – Removed all references to Commercial and Industrial temperature.

All products are now Industrial temperature. Changed Section 4.2.1 EEPROM

4.2.1 EEPROM 4.2.1 EEPROM

4.2.1 EEPROM

Byte Read

Byte ReadByte Read

Byte Read to allow multiple byte reads.

Version 1.6 4/30/2004 – Added warranty information. Updated agency compliancy. Added

new RSSI plot. Updated Channel Number information. Added configuration flow

chart and timing diagrams. Updated approved antenna table. Added AC4424-

10A information.

Version 1.7 5/5/2004 – Modified references from Table 9 to Table 11.

Version 1.8 5/10/2004 – Changed start-up time to reflect addition of microprocessor

supervisor. Updated Auto Config table.

Version 1.9 5/10/2005 - Added the following CC Commands; Sync Channel, EEPROM Byte

Read/Write and Soft Reset. Added AT Commands. Removed Configuration

command documentation (though the firmware will continue to support their

usage). Added Auto Destination and Random Backoff.

Version 2.0

Version 2.1

3/23/2006 - Removed Stream mode, FEC and Frequency Offset documentation.

Corrected Random backoff byte.

5/8/2007 – Updated RF channel settings and Table 10. Updated EEPROM

parameters section and added descriptions to all fields. Updated the EEPROM

byte write command description.