User's Manual

Regulatory Information
Regulatory Information Regulatory Information
Regulatory Information
5
55
5/
//
/8/2007
8/20078/2007
8/2007 40
4040
40
8.
8.8.
8. Regulatory Information
Regulatory InformationRegulatory Information
Regulatory Information
Agency Identification Numbers
Agency Identification NumbersAgency Identification Numbers
Agency Identification Numbers
Part Number
Part NumberPart Number
Part Number US/FCC
US/FCCUS/FCC
US/FCC CAN/IC
CAN/ICCAN/IC
CAN/IC EUR/EN
EUR/ENEUR/EN
EUR/EN
AC4424-9AJ KQL-44249AJ 2268C-44249AJ CE
AC4424-10 KQL-PKLR2400 CAN2268391158A
AC4424-100 KQL-AC4424 CAN2268C391190A CE
AC4424-200
KQL-PKLR2400-
200
CAN2268391180A
8.1
8.18.1
8.1 FCC
FCCFCC
FCC
The user is responsible for all labeling and ensuring the module complies with FCC regulations
(see 47CFR2 for exact regulations).
• The FCC identifier proceeded by “FCC ID:” and the FCC Notice found below
must be clearly visible on the outside of the equipment.
• The RF Exposure Warning (next page) also must be printed inside the
equipment’s user manual.
The FCC/IC approval was granted with the module classified as mobile (ie. the antenna is
>20 cm from the human body with the exception of hands, wrists, feet, and ankles). The
end user needs to ensure that the antenna location complies with this or retest for
portable classification (less than 2.5 cm with the same exceptions as mobile) at their
own expense.
FCC regulations allow the use of any antenna of the same type and of equal or less gain.
However the antenna is still required to have a unique antenna connector such as MMCX
or reverse SMA. On the following page is a table of antennas available through
AeroComm. Any different antenna type or antenna with gain greater than those listed
must be tested to comply with FCC Section 15.203 for unique antenna connectors and
Section 15.247 for emissions at user’s expense.
Caution
CautionCaution
Caution: Any changes or modifications not expressly approved by AeroComm could void
the FCC compliancy of the AC4424.