User Manual

50289-BDA

USE OR DISCLOSURE OF DATA CONTAINED ON THIS PAGE IS SUBJECT TO THE

RESTRICTION ON THE TITLE PAGE OF THIS MANUAL

2. Locate the dual power supply modules (2 ea.), the single power supply module (1 ea.)

and the battery charger module (1 ea.).

The modules are distinguished by the following features:

• The dual power supply modules have two large gold power supplies (made by

Acopian) mounted side-by-side in the chassis.

• The single power supply module has a single gold Acopian power supply mounted on

the left side of the chassis (when viewed from the front).

• The battery charger module has a single yellow TrueCharge 40™ battery charger

(made by StatPower) mounted on the right side of the chassis (when viewed from the

front). The battery charger module is shown in Figure 4.

Figure 4. Battery Charger ModuleFigure 4. Battery Charger Module

CAUTION

MAKE SURE THE POWER SUPPLIES AND CHARGER ARE SWITCHED OFF

PRIOR TO INSTALLATION. THESE UNITS ARE OFF WHEN THE CIRCUIT

BREAKER PUSS-PULL SWITCHES ON THE FRONT PANEL ARE PULLED

OUT (THE WHITE BAND AROUND THE BODY OF THE SWITCH IS VISIBLE).

3. Load one dual power supply module into the High Band equipment cabinet. This

module goes directly above the LNA / 8-Way Splitter Module.