User Manual

50289-BDA

USE OR DISCLOSURE OF DATA CONTAINED ON THIS PAGE IS SUBJECT TO THE

RESTRICTION ON THE TITLE PAGE OF THIS MANUAL

Figure 6. Power & Signal Connections on thFigure 6. Power & Signal Connections on th

e Rear of the Power Amplifiere Rear of the Power Amplifier

(as viewed from the top)(as viewed from the top)

POWER AMPLIFIER

7-PIN MALE CIRCULAR

CONNECTOR (DC POWER)

AMP 206137-1

9-PIN MALE CIRCULAR

CONNECTOR (SIGNAL)

AMP 206705-1

INSTALLING THE IF CHANNEL MODULES

The channel slots have been factory preset to be installed in order, from low to high

frequency, from left to right, in the VME-style IF Channel rack located in lower middle

of each cabinet.

Note that each IF channel module is labeled with the frequency to which it was factory-

tuned; the frequency is written on the “TESTED” sticker located on the top rear corner of

the RF enclosure in each module.

Also note the bank of jumpers at the rear of each IF channel module; the jumper position

determines the keying of the power amp directly below the IF channel rack and,

consequently, which slot each IF channel module should be placed in. The IF channel

module slots are ordered 1 through 8 from left to right.

The factory preset frequencies and jumper settings for the High- and Low-Band IF

Channel Modules are listed in Table 1. Jumper location is depicted in Figure 7