User Manual

50289-BDA

USE OR DISCLOSURE OF DATA CONTAINED ON THIS PAGE IS SUBJECT TO THE

RESTRICTION ON THE TITLE PAGE OF THIS MANUAL

DUPLEXER CABLING (CONTINUED)

Locate the two long type-N male to male semi-rigid cables formed as shown in Figure 11.

These cables are used to connect the Duplexer Modules to the 8-Way Splitters.

Install one cable in the High Band cabinet, connecting the Duplexer OUT port to the 8-

Way Splitter IN port. When installed properly, the cable runs down the right side of the

cabinet. Refer again to the photo of the finished cable installation shown in Figure 11.

Install the other cable in the Low Band cabinet in the same manner.

Figure 11. Semi-Rigid Cable for ConnectingFigure 11. Semi-Rigid Cable for Connecting

the Duplexer to the 8-Way Splitter the Duplexer to the 8-Way Splitter