User Manual

50289-BDA

USE OR DISCLOSURE OF DATA CONTAINED ON THIS PAGE IS SUBJECT TO THE

RESTRICTION ON THE TITLE PAGE OF THIS MANUAL

POWER AMPLIFIER CABLING

1. Locate the two 16” long type-N male to male semi-rigid cables formed as shown in

Figure 12. These cables are used to connect the Power Amplifiers to the output feed-

thru connectors on the lower right side of the cabinets.

2. Install one cable in the High Band cabinet, connecting the Power Amplifier OUT port

to the feed-thru connector on the lower right side of the cabinet.

3. Install the other cable in the Low Band cabinet in the same manner.

Figure 12. Semi-Rigid Cable Connecting theFigure 12. Semi-Rigid Cable Connecting the

Power Amplifier to the Cabinet-Mounted Power Amplifier to the Cabinet-Mounted

Feed-Thru Connector Feed-Thru Connector

(dimensions are approximate)

SIDE VIEW

16”

2”

Type-N Male

FRONT VIEW