User Manual

50289-BDA

USE OR DISCLOSURE OF DATA CONTAINED ON THIS PAGE IS SUBJECT TO THE

RESTRICTION ON THE TITLE PAGE OF THIS MANUAL

SETTING THE FREQUENCY

Each module’s frequency may be set using the User’s software. The User’s software

allow the operator to change the frequency of the module to any other frequency within

the operating band.

CHANGING THE CHANNEL ID

The channel ID is an optional software upgrade to the 800 MHz-Linc software.. The

channel ID identifies each channel module. This is useful if modules are moved around

or a new module is installed in place of a defective one. Normal channel IDs are depicted

in Figure 17.

CHANGING THE CHANNEL SERIAL NUMBER

The serial numberis an optional ugradeto the 800MHz-Linc software. The serial number

of each channel module is stored in non-volatile memory. This is an optional function

and not normally programmed. The channel serial number can be used for customer asset

tracking.

Figure 17. Normal Channel ID Numbering SchFigure 17. Normal Channel ID Numbering Sch

emeeme

CH1CH1 CH2CH2 CH3CH3 CH4CH4 CH5CH5 CH6CH6 CH7CH7 CH8CH8