User Manual

50289-BDA

USE OR DISCLOSURE OF DATA CONTAINED ON THIS PAGE IS SUBJECT TO THE

RESTRICTION ON THE TITLE PAGE OF THIS MANUAL

MODE SETTING

The channel mode may be set to either CONTINUOUS or RSSI (Received Signal

Strength Indication). In the continuous mode, the channel is always keyed and

continuously transmitting. In the RSSI mode, the channel is keyed only when the

incoming signal strength is above the factory set threshold level. Normal operation will

be in RSSI mode; continuous mode is normally used for testing.

CHANGING THE MODE

To change the Mode, click the function button Mode at the bottom of the main screen. A

mode setting window seen in Figure 26 below, appears with a picture of a switch on it

showing which is the current Mode of the channel is. Click the Keyed or CONT

(continue) button to set the desired mode. Alternatively, you can click the picture of the

switch to toggle the mode. Click Exit button on the setting board to go back to the main

screen.

Figure 26. Set Mode windowFigure 26. Set Mode window

EXITING THE SOFTWARE