User Manual

50289-BDA
USE OR DISCLOSURE OF DATA CONTAINED ON THIS PAGE IS SUBJECT TO THE
RESTRICTION ON THE TITLE PAGE OF THIS MANUAL
52
An optional feature of the software is setting and changing the Channel ID. The channel
ID can be set for each channel module. This is useful if modules are swapped around or a
new module is installed in place of a defective one. Normal channel IDs are depicted in
Figure 17.
CHANGING THE CHANNEL SERIAL NUMBER
Another optional feature of the software is setting and changing the channel serial
number. The channel serial number could be used to assist with asset tracking.
SETTING ATTENUATION
To set Attenuation: click the function button Attenuation at the top of the main screen.
An Attenuation setting window appears with the current setting shown in dB seen below
in Figure 31. Click the down arrow next to the text box, a drop down list of available
attenuation setting are displayed. Click the desired new setting and then with the mouse,
click the Set button to confirm the change to the attenuation setting. Click Exit button on
the setting board to go back to the main screen.
Figure 31. Set Attenuation windowFigure 31. Set Attenuation window
SETTING A FREQUENCY