User's Manual
Table Of Contents
- Part Number
- Overview
- AC4424 Specifications
- Specifications
- Configuring the AC4424
- EEPROM Parameters
- EEPROM Configuration Commands
- On-the-Fly Control Command Reference
- Status Request
- Change Channel with Forced Acquisition Sync
- Server/Client Command
- Power-Down Command
- Power-Down Wake-Up Command
- Broadcast Mode
- Read Static Bank #1 Byte
- Write Static Bank #1 Bytes
- Read Static Bank #2 Bytes
- Write Static Bank #2 Bytes
- Write Destination Address
- Read Destination Address
- Temperature Update
- Theory of Operation
- Application Examples
- Dimensions
- Ordering Information
12/09/02
12/09/0212/09/02
12/09/02
4
44
4
FCC INFORMATION
FCC INFORMATIONFCC INFORMATION
FCC INFORMATION
Agency App
Agency AppAgency App
Agency Approval Overview
roval Overviewroval Overview
roval Overview
Part Number
Part NumberPart Number
Part Number
US/FCC
US/FCCUS/FCC
US/FCC
CAN/IC
CAN/ICCAN/IC
CAN/IC
EUR/EN
EUR/ENEUR/EN
EUR/EN
Portable
PortablePortable
Portable
Mobile
MobileMobile
Mobile
Fixed
FixedFixed
Fixed
AC4424-10 X X X X X X
AC4424-100 X X X X-32cm* X-32cm*
AC4424-200 X X X-32cm* X-32cm*
* See RF Exposure warning on next page
Note: The product approvals above are with antennas specified below.
Agency Identification Numbers
Agency Identification NumbersAgency Identification Numbers
Agency Identification Numbers
Part Number
Part NumberPart Number
Part Number
US/FCC
US/FCCUS/FCC
US/FCC
CAN/IC
CAN/ICCAN/IC
CAN/IC
EUR/EN
EUR/ENEUR/EN
EUR/EN
AC4424-10 KQL-PKLR2400 CAN2268391158A X
AC4424-100 X X X
AC4424-200 KQL-PKLR2400-200 CAN2268391180A
WARNING:
WARNING: WARNING:
WARNING:
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including
interference that may cause undesired operation.
WARNING:
WARNING: WARNING:
WARNING:
This device has been tested with an MMCX connector with the antennas listed
below. When integrated in the OEMs product, these fixed antennas require
installation preventing end-users from replacing them with non-approved
antennas. Any antenna not in the following table must be tested to comply with
FCC Section 15.203 for unique antenna connectors and Section 15.247 for
emissions.
WARNING:
WARNING: WARNING:
WARNING:
The Original Equipment Manufacturer (OEM) must ensure that FCC labeling
requirements are met. This includes a clearly visible label on the outside of the
OEM enclosure specifying the appropriate AeroComm FCC identifier for this
product as well as the FCC Notice above. The FCC identifiers are listed above
in the Agency Identifier Numbers section.
FCC Notice
FCC NoticeFCC Notice
FCC Notice
Labeling Requirements
Labeling RequirementsLabeling Requirements
Labeling Requirements
Antenna Warning
Antenna WarningAntenna Warning
Antenna Warning
Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.