User's Manual

Command Set
Preliminary 25
6.1.4 Standby* (THIS COMMAND NOT YET SUPPORTED)
This command is issued by the Host processor to put the Radio in one of two low power modes.
For mode 0, the Radio should disable the radio and enter a low power state. The hop synching is the only
allowed operation in this mode. For mode 1, the Radio should go into deep sleep mode. The Radio should
come out of low power modes when a command is issued from the Host processor. This command requires
an acknowledge.
Command: 88H
Length: 01H
Data: 0 - indicates low power mode, 1 - indicates sleep mode.
Data Frame:
88H 01H 00H Data Checksum
6.1.5 Reset EEPROM*
This command is sent by the OEM Host to the Radio, the result of which sets the various
locations/parameters in the EEPROM to their default values. The execution of this command does NOT
affect the IEEE Address and Operation Mode parameters in the EEPROM. This command returns a generic
positive acknowledgment.
6.1.6 Status Request*
This command is sent by the OEM Host to the Radio to find out the various statistics associated
with the RF Data Link Layer. The Radio sends back the values of the various parameters/statistics as part of
the Status Reply command. 1 byte of data is supplied along with the command that determines whether the
Radio resets the various Error Counters or not.