Use and Care Manual

ManualsBrandsAeroCool ManualsEvaporative Coolers2000 CFM 2-Speed Portable Evaporative Cooler for 1400 sq. ft.

02-999-1773 – (Rev - )

OWNER’S GUIDE

USE AND CARE MANUAL

MODEL MB10 & MB20

For Customer Assistance

CALL 1-800-325-6952

Congratulations: You have purchased a product of superior

performance and design, which will give the best service when

properly operated and maintained. These coolers can be used as

convenient, roll-around spot coolers.

This guide was designed to provide you with the information

needed to assemble the unit for roll-around spot-cooling. It also

contains information on how to safely operate, inspect, maintain

and troubleshoot your evaporative air cooler.

The first section, Assembly, contains instructions to prepare your

cooler for roll-around portable service. The second section,

Maintenance, contains operational and maintenance instructions

to aid in keeping your unit in good working order, while

Troubleshooting includes information to help diagnose and repair

commonly encountered problems.

Summary of content (6 pages)

PAGE 1
OWNER’S GUIDE USE AND CARE MANUAL MODEL MB10 & MB20 For Customer Assistance CALL 1-800-325-6952 Congratulations: You have purchased a product of superior performance and design, which will give the best service when properly operated and maintained. These coolers can be used as convenient, roll-around spot coolers. This guide was designed to provide you with the information needed to assemble the unit for roll-around spot-cooling.
PAGE 2
Install drain bushing and standpipe Install overflow drain bushing in bottom of cooler. Slide rubber washer over drain bushing, push drain bushing through bottom of cooler, and tighten nut. Screw plastic overflow standpipe into the drain bushing and tighten snugly (hand-tight) to prevent leakage. Where conditions allow for drainage, connect a drain line (garden hose) to drain bushing and drain INTRODUCTION Your evaporative air cooler was thoroughly tested and inspected before leaving the factory.
PAGE 3
In case of trouble in any of these stages, refer to the Troubleshooting Chart on page 6. Electric Power Cabinet Inspection Checklist CAUTION: After initial start-up and during periodic inspections, check for and/or observe the following: Refer to the Troubleshooting Chart on page 6 if necessary. This cooler is designed for connection to 120 volt AC, 60 Hz (cycle) power only. NOTE: Improper voltage will void the pump and/or motor warranties and may cause serious personal injury or property damage.
PAGE 4
CAUTION: Disconnect all electrical power to the Cleaning Water Pump & Hose cooler by removing plug from receptacle before attempting to install, open, or service your cooler. CAUTION: Do not allow pump to fall over and become Even while routinely inspecting or servicing the inside, the cooler can be accidentally started. Keep all personnel away from the cooler and electrical supply when you are working on it.
PAGE 5
lubricating the motor. Under normal use, these motors require oiling about every 12 months of operation. Do Not Over-Oil. Blower Shaft Bearings Blower shaft bearings need periodic lubrication. The oil cups on the bearings should be filled with SAE 30W non-detergent oil when necessary. Under normal use, oiling is required every three months of operation. Do Not Over-Oil.
PAGE 6
WIRING DIAGRAM TROUBLESHOOTING GUIDE: Should an obvious problem occur with your cooler consult the following table. If you cannot correct the problem, or if it persists, contact qualified service personnel.