INSTRUCTION MANUAL Model Name: Model Name:PACTRIO PacTrio Manufactured for: Phoenix Manufacturing Inc.
BEFORE USING YOUR NEW BRISA COOLER: Please read this guide. It will help you to operate your new PACTRIO cooler/heater in the safest and most effective way. Keep this book and your sales receipt in a safe place for future reference. IMPORTANT SAFETY INSTRUCTIONS: Read all instructions in this guide before using your PACTRIO. This product is intended for indoor residential use only, not for industrial or other commercial applications.
IMPORTANT INSTRUCTIONS CONTD.: 17. The water level should not exceed the MAX line. Ensure the water level is above the MINIMUM required when using cooler or humidifier. 18. After adding water into the unit, Do NOT lean or tip over to keep water from over flowing. Do NOT move abruptly to keep water from spilling. 19. If unit falls down with water in it, immediately unplug and wait 24 HOURS before attempting to use. ! WARNING SHOCK HAZARD Use your PacTrio only in dry environments.
COOLER/ HUMIDIFIER SLEEP NATURAL FAN HEATER 8H 6H HI 4H MED 2H 1H LOW HI ON/OFF CLEAN FILTER OSCILLATION SPEED TIMER 1 COOLER / HUMIDIFIER MODE 2 HEAT / FAN MODE Recirculates and filters the water located at the base to generate cool air 3 ON / OFF MODE Will turn the entire unit on or off 4 CLEAN FILTER MODE Indicator will show a light and beep every 100 hours of operation while being used as a COOLER/HUMIDIFIER.
41°F - 109°F RH<95% (77°F) REMOTE CONTROL: Control Panel 1 2 5 6 3 7 4 Remote Control Panel 1 ON / OFF MODE Instruction Will turn the entire unit on or off 3.
OPERATING INSTRUCTIONS: FUNCTIONAL KEYS a) ON/OFF: Plug in the appliance and press the MAIN POWER switch on the side of the unit to (l). Listen for two beeps to indicate that the unit is powered on. Press the control panel ON/OFF key to activate the appliance. Other keys will not function until the ON/OFF key is switched on. Once activated, the unit enters fan mode. Pressing the ON/OFF key a second time immediately shuts the appliance off in FAN mode.
OPERATING INSTRUCTIONS contd. : NOTICE • Add water before starting the COOLER/HUMIDIFIER mode. Turn the water tank knob counterclockwise 90° and pull out water tank drawer. • Pay attention to the minimum level line when adding water. Always keep water level higher than minimum level line, or noisy operation and water pump damage may result. • When adding water, do NOT over fill above MAX level line. • Always use clean water. • After adding the water, close and lock the water tank drawer.
OPERATING INSTRUCTIONS - REMOTE CONTROL: 1. Open the battery cover on the back of the remote control and install the battery. Insert a coin or equivalent tool in the cover slot. Turn the cover to the OPEN position to open and remove it. Replace the cover and turn to the CLOSE position to secure it in place. 2. Aim at the receiver window on the unit control panel. The effective remote control distance is within 20 feet. 3.
MAINTENANCE: WARNING: Do NOT attempt to service or clean unit while the unit is plugged in. ALWAYS disconnect the power cord before attempting to clean filters, water tank or surface area of unit. OUTER FILTER: Periodically check the filter at least once a month. To check, carefully un-clip the outer filter, remove it, and use a soft brush to clean it free of dust. You may also rinse the filter clean beneath a faucet. If cleaning with water, thoroughly dry the filter before clipping it back into place.
Limited Warranty: Phoenix Manufacturing, Inc. (PMI) extends this limited warranty to the original purchaser of this evaporative cooler when installed and used under normal conditions. It does not cover damages incurred through accident, neglect, or abuse by the owner. Also, we do not authorize any person or representative to assume for PMI any other or different liability in connection with this product.