User's Guide

16 / 18
(2) this device must accept any interference received, including
interference that may cause undesired operation.”
The module is limited to installation in mobile or fixed applications. Separate approval is
required for all other operating configurations, including portable configuration with respect to
Part 2.1093 and different antenna configurations. *****
The requirement for KDB 996369 D03:
List of applicable FCC rules
FCC CFR Title 47 Part 15 Subpart C Section 15.247, Part 15 Subpart E Section 15.407
Summarize the specific operational use conditons
This module has been granted Single Modular Approval for mobile applications. OEM
integrators for host products may use the module in their final products without additional FCC
certifications if they meet the following conditions. Otherwise, additional FCC approvals must
be obtained.
The host product with the module installed must be evaluated for simultaneous
transmission requirements
The user's manual for the host product must clearly indicate the operating requirements
and conditions that must be observed to ensure compliance with current FCC RF exposure
guidelines.
To comply with FCC regulations limiting both maximum RF ourput power and human
exposure to RF radiation, the maximum antenna gain including cable loss in a mobile-only
exposure condition must not exceed the 2dBi.
A label must be affixed to the outside of the host product product with the following
statement: This device contains FCC ID: UVF-VISTA9113DWAG
The final host/Module combinations may also need to be evaluated against the FCC Part
15B criteria for unintentional radiators in order to be properly authorizaed for operation as a
Part 15 digital device.
Information on test modes and additional testing requirements
Date transfer module demo board can control the EUT work in RF test mode at specified
test channel.
Additional testing, Part 15 Subpart B disclaimer
The module without unitentional-radiator digital circuit, so the module does not required
an evaluation
by FCC Part 15 Subpart B. The host be evaluated by the FCC Subpart B.
Single module procedures
The module has meet the requirements to satisfy the conditions.
Trace antenna designs
Please refer to Picture 1 for the RF Link’s schematic diagram and refer to Picture 2 for
PCB Layout. The designed antenna meets the wifi hardware module’s requirements via the
connection between ipex connector and module.