Manual

Aeromotive Commonly Used Fittings

15607 AN-08 ORB to AN-08 Flare (bypass fitting)

15608 AN-10 ORB to AN-10 Flare (Inlet/outlet fitting)

15610 AN-10 ORB to AN-08 Flare (outlet fitting only)

15642 AN-10 ORB to AN-12 Flare (inlet fitting)

A high capacity, fuel filter must be installed between the pump inlet and outlet. We recommend an Aeromotive AN-

10 size, replaceable element filter on the outlet and a AN-12 on the inlet. Call us for info.

Aeromotive AN-10 Fuel Filter P/N’s

12301 Red 10 micron Fuel Filter

12321 Black 10 micron Fuel Filter

12351 Chrome 10 micron Fuel Filter

12335 Red 40 micron Fuel Filter

12304 Red 100 micron Fuel Filter

12324 Black 100 Micron Fuel Filter

12354 Chrome 100 micron Fuel Filter

12331 Black 100 micron Fuel Filter w/ Shutoff Valve

Aeromotive AN-12 Fuel Filter P/N’s

12302 Nickel 100 micron Fuel Filter

12309 Hard Coat Black 100 Micron Fuel Filter

12310 Nickel 10 micron Fuel Filter

12311 Hard Coat Black 10 Micron Fuel Filter

12332 Black 100 micron Fuel Filter w/ Shutoff Valve

12352 Chrome 100 micron Fuel Filter

12360 Chrome 10 micron Fuel Filter

The following steps are typical of most installations:

1. Once the engine has been allowed to cool, disconnect the negative battery cable and relieve the fuel

system pressure.

2. Disconnect the existing pump fuel lines. Plug the open fuel line ends to prevent foreign matter from

entering the fuel system. Remove pump mounting screws and remove the existing pump. If you are

replacing a similar competitor’s fuel pump, the Aeromotive fuel pump comes with additional mounting

bracket holes underneath the Aeromotive mounting bracket which may be compatible.

Note: DO NOT RUN THE PUMP DRY!!! Excessive wear will result if the pump runs dry. DO NOT

DISASSEMBLE THE PUMP!!! Tight tolerances, material selection and calibration of this unit are

key to the performance. DISASSEMBLY WILL THROW THE PUMP OUT OF CALIBRATION

AND VOID ANY/ALL WARRANTIES ON THIS PRODUCT.

3. Find a suitable place on the vehicle chassis to mount the Aeromotive fuel pump. Make sure the

location will accommodate the pump mounting bolts, will position the pump lower than the fuel tank, is

clear of the exhaust, is clear of any moving suspension or drivetrain components and will keep the

pump clear of road obstructions or debris.

4. Using the pump mounting bracket as a template mark and drill two mounting holes to accept ¼” bolts.

Mount the fuel pump using two ¼” bolts, nuts and lock washers. Make sure and mount the pump in

the vertical, upright position.

Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components,

and any exhaust components! Protect fuel lines from abrasion and road obstructions or debris.

5. Connect the fuel cell pickup to the 100 micron fuel filter inlet. This section of fuel line should be as

short as possible to reduce the tendencies for vapor lock, cavitation, and premature wear of your

Aeromotive fuel pump.