User guide

ManualsBrandsAeromotive ManualsCar14116 - 05-09 4.6L 3-VALVE GT FUEL RAIL KIT

AEROMOTIVE

Part # 14116

’05-‘06 Mustang GT Fuel Rails

INSTALLATION INSTRUCTIONS

CAUTION:

Installation of this product requires detailed knowledge of automotive

systems and repair procedures. We recommend that this installation be carried

out by a qualified automotive technician.

Installation of this product requires handling of gasoline. Ensure you are

working in a well ventilated area with an approved fire extinguisher nearby.

Extinguish all open flames, prohibit smoking and eliminate all sources of ignition

in the area of the vehicle before proceeding with the installation.

When installing this product, wear eye goggles and other safety apparel as

needed to protect yourself from debris and sprayed gasoline.

WARNING!

The fuel system is under pressure. Do not open the fuel system until the

pressure has been relieved. Refer to the appropriate vehicle service manual for

the procedure and precautions for relieving the fuel system pressure.

Aeromotive system components are not legal for sale or use on emission controlled motor vehicles.

The enclosed fuel rails are intended for use on by-pass style fuel systems, for installation on non-

bypass systems a fuel pressure sensor adapter, Aeromotive p/n 15115, is available through your

local speed shop.

The enclosed Aeromotive fuel rails utilize o-ring sealed AN-08 style ports; these ports are NOT

PIPE THREAD and utilize NO THREAD SEALANT. To use the enclosed fuel rails in your vehicle’s

fuel system you must install the necessary adapter fittings and o-rings, high pressure fuel lines

and regulator to adapt your system to the configuration and ports of these fuel rails. Please call

for a catalog of the complete line of quality Aeromotive products.

When installing o-rings it is important to place a small amount of light oil on both the o-ring and

the mating surface to ease installation and prevent damaging the o-ring.

The following installation instructions are for a typical installation, for specific year and model

installation instructions please refer to your vehicles service manual.

Summary of content (4 pages)

PAGE 1
AEROMOTIVE Part # 14116 ’05-‘06 Mustang GT Fuel Rails INSTALLATION INSTRUCTIONS CAUTION: Installation of this product requires detailed knowledge of automotive systems and repair procedures. We recommend that this installation be carried out by a qualified automotive technician. Installation of this product requires handling of gasoline. Ensure you are working in a well ventilated area with an approved fire extinguisher nearby.
PAGE 2
1. Once the engine has been allowed to cool, disconnect the negative battery cable and relieve fuel system pressure, referring to the appropriate vehicle service manual for the procedure on doing so. 2. Check for any dirt or debris around the fuel injectors. If any is evident, wash it off with some solvent parts cleaner or wipe it off with a clean shop towel. 3. Disconnect the electrical connector at each injector, making note of the location of each. 4.
PAGE 3
15. Carefully place each of the fuel injectors in the corresponding fuel injector bore of the Aeromotive fuel rails. 16. Place each of the fuel rail / injector assemblies onto the lower intake manifold, ease the fuel injectors into the injector bores in the lower intake being careful that the injector does not dislodge itself from the fuel rail.
PAGE 4
AEROMOTIVE, INC. LIMITED WARRANTY This Aeromotive Product, with proof of purchase dated on or after January 1, 2003, is warranted to be free from defects in materials and workmanship for a period of one year from the original date of purchase. No warranty claim will be valid without authentic, dated proof of purchase. This warranty is to the original retail purchaser and none other and is available directly from Aeromotive and not through any point of distribution or purchase.