User guide

14. Now take Aeromotive fuel pump assembly and slide the leveling unit into it as illustrated in FIGURE 1-5. NOTE:
When twisting the bottom tabs inward, be sure not to twist them into the wires on the bottom of the leveling
unit. Move the leveling arm through it’s full range of motion to ensure it clears the bracket tabs.
FIGURE 1-5
15. Cut the two wire connector off of the fuel level sensor and crimp them onto the two wires provide on the pump. NOTE:
The sensor is a resistance output only, wiring polarity is bi-directional.
16. Make sure to place the factory o-ring in the receiver groove on the tank Figure 1-6. Failure to do so will result in fuel
leakage and require removal of the tank again.
FIGURE 1-6