Instruction manual

Quick Start Card
OPEN & READ ALL INSTRUCTIONS
BEFORE OPERATING!
Medication Cup Cap
Mouthpiece
Medication Cup
(with OnQ
®
Aerosol
Generator)
Ventilation Holes
Nebulizer Body
Battery Powered Controller
with detachable power cord
- Model 7010 -
AC/DC Controller
with attached power cord
- Model 7030 -
Thank you for purchasing the Aeroneb Go Micropump
Nebulizer from evo Medical Solutions!
To optimize the
performance and life expectancy of your Aeroneb Go device,
follow the cleaning instructions carefully as instructed on
page 10 of your Aeroneb Go Instruction Manual.
Retain this card with your device for future reference.
IMPORTANT ATTENTION
As with any mechanical device, this product may become
unusable due to an electrical outage, battery depletion,
or mechanical failure. We recommend that you have spare
batteries and have a backup device available to you.
If this product is being used to treat a life threatening
condition, a backup device is necessary.
IMPORTANT CAUTION
Before you begin any operation, continue to the
Quick Start Instruction Guide read throughly and
follow the operating instructions that apply to
your specific model.
BEFORE ANY OPERATION
To optimize the performance and life expectancy of
your Aeroneb Go device, follow the cleaning instructions
carefully as instructed on page 10 of your Aeroneb Go
Instruction Manual.
NOTE: Removal and the improper insertion of the retaining ring
from the underside of the medication cup may cause the unit to leak
or malfunction.
NOTE: Please read all instructions before using. Refer to your
Aeroneb
®
Go Nebulizer Instruction Manual for more complete
cleaning instructions.
To order replacement parts or accessories, visit your local home
medical equipment dealer or pharmacy.
If you have any questions or problems regarding your Aeroneb
®
Go
nebulizer, contact your local home medical equipment dealer or
pharmacy.
Your Aeroneb
®
Go was tested and inspected at the factory and is a
premium device that has a life expectancy of at least one year (730
treatments) with proper care and cleaning. Lack of proper care and
cleaning, disassembly of the retaining ring or misuse will void the
warranty.
IMPORTANT CLEANING
INFORMATION FOR ALL MODELS
TO ASSEMBLE NEBULIZER UNIT
STEP 1
Before you begin, run the Medication Cup
under hot water, then tap the cup slightly.
STEP 2
Connect the Medication Cup (containing the
OnQ
®
Aerosol Generator) to the Nebulizer Body.
NOTE: Make sure the Aeroneb Go is unplugged
before you add medication to the Medication
Cup.
STEP 3
Fill the Medication Cup with the prescribed
nebulizer medication. Never pour more than
6 mL into the cup. The continuous line on
the inside surface of the cup indicates the
maximum filling level. (When the medication
cup contains medication, the cup should
remain in an upright position).
CAUTION: To avoid damage to the nebulizer
unit, do not use a syringe with needle.
STEP 4
Securely place Cap on Medication Cup.
STEP 5
Attach Mouthpiece or Mask Connector and
mask to Nebulizer Body. NOTE: Masks are an
optional accessory and may be purchased
through evo Medical Solutions or your
Aeroneb
®
Go dealer.
QUICK START INSTRUCTION
GUIDE BEGINS HERE
CONTINUE ON BACK
FOR MORE INSTRUCTIONS