Instruction manual

14
TROUBLESHOOTING GUIDE
If you have difculty operating your Aeroneb
®
Go, check the
following points:
Problem Check Remedy
No visible
aerosol
when using
batteries
Check that the
batteries are
inserted correctly.
Using the markings
under each battery
location, place
each battery in the
Control Module
housing. Match (+)
and (-).
Check to see if the
low battery power
light is ashing.
Replace the
batteries or use the
AC/DC Adapter.
Check that the
Control Module
cable is connected
properly to the
nebulizer and to the
Control Module.
Connect the cable
properly to the
nebulizer and the
Control Module
(Refer to page 8).
No visible
aerosol when
using AC/DC
adapter
Check that the
AC/DC Adapter is
plugged correctly
into a working AC
outlet and the green
light is on the AC/DC
Adapter.
Insert the plug into
a working outlet
and verify that the
green light on the
controller is lit (Refer
to page 10).
Check that the
AC/DC Adapter
cable is connected
properly to the
Control Module.
Connect the
AC/DC Adapter
cable properly to
the Control Module
(Refer to page 10).