Instruction manual
ASSEMBLY
1. Connect the Medication Cup
(containing the OnQ
™
Aerosol
Generator) to the Nebulizer Body.
NOTE: Make sure the Aeroneb
®
Go is unplugged before you add
medication to the Medication Cup.
2. Fill the Medication Cup with the
prescribed nebulizer medication.
Never pour more than 6 mL into the
cup.The continuous line on the inside
surface of the cup indicates the
maximum filling level. (When the
medication cup contains medication,
the cup should remain in an upright
position).
CAUTION: To avoid damage to the nebulizer unit, do not use a
syringe with needle.
4. Place the Cap on the Medication Cup.
5. Attach Mouthpiece or Mask Connector
and mask to Nebulizer Body.
NOTE: Masks are an optional accessory and may be purchased
through evo Medical Solutions or your Aeroneb
®
Go dealer.
13
6
VINEGAR SOLUTION: (Cont.)
III. Soak the Nebulizer Unit parts (Medication Cup and Cap,
Nebulizer Body, and Mouthpiece or Mask Adapter and Mask)
in the solution for thirty (30) minutes.
IV. Rinse all pieces thoroughly under running hot tap water.
V. Shake off excess water, and allow parts to air dry on a clean,
dry towel, out of the reach of children.
VI. Make certain that all disinfected parts are completely dry
before you store them.
CONTROL lll GERMICIDE:
If you would like to disinfect your nebulizer, you may use
the medical disinfectant described below, available from your
supplier.
Use only Control lll Laboratory Germicide (Maril Products Inc.) or
an equivalent medical disinfectant to disinfect your nebulizer.
l. First, clean the Nebulizer Unit as described in the Daily
Cleaning Section, following Steps 1-3.
Il. Disinfect the Nebulizer Unit parts (Medication Cup and Cap,
Nebulizer Body, and Mouthpiece or Mask Connector Elbow
and Mask) according to the manufacturer instructions for the
medical disinfectant.
lll. Clean the Nebulizer Unit again as described in the Daily
Cleaning Section to remove any residual Control lll.
lV. Shake off excess water, and allow parts to air dry on a clean,
dry towel, out of the reach of children.
V. Make certain that all disinfected parts are completely dry
before you store them.