Certifications 2

SAFETY DATA SHEET
according to Regulation (EC) No. 1907/2006 (REACH)
Revision date: 01-Jun 2017
Print date: 14-Aug-2019
Version: 2
Page 4/8
ÄRONIX Kontaktpaste "CU"
7.3. Specific end use(s)
Recommendation:
Observe technical data sheet.
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
No data available
8.2. Exposure controls
8.2.1. Appropriate engineering controls
No data available
8.2.2. Personal protection equipment
Eye/face protection:
Eye glasses with side protection DIN EN 166
Skin protection:
Tested protective gloves must be worn DIN EN 374 Suitable material: Breakthrough time (maximum
wearing time) min In the case of wanting to use the gloves again, clean them before taking off and air
them well. Breakthrough times and swelling properties of the material must be taken into consideration.
8.2.3. Environmental exposure controls
No data available
8.3. Additional information
No data available
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Appearance
Physical state: Paste Colour: copper
Odour: characteristic
Safety relevant basis data
9.2. Other information
No data available
en / DE / CN
parameter
at °C
Method
Remark
pH
not determined
Melting point
> 230 °C
F reezing point
not determined
Initial boiling point and boiling
range
not determined
Decomposition temperature (°C):
not determined
Flash point
> 100 °C
Evaporation rate
not determined
Ignition temperature in °C
not determined
Upper/lower flammability or
explosive limits
not determined
Vapour pressure
not determined
Vapour density
not determined
R elative density
0.86 – 0.89
g/cm³
20 °C
Bulk density
not determined
W ater solubility (g/L)
not determined
P artition coefficient: n- octanol/
water
not determined
Dynamic viscosity
not determined
Kinematic viscosity
not determined
40 °C