User's Guide

Form #: OP_01_TM
Title: Aeronix Data Links – EDL Nano Products User Guide
Document Number: AE301628-001
Revision: B Date: 3 October 2019
Aeronix Proprietary
22
The system will allow the user to configure 10 Subscribers.
Figure 3-7 Example Adding a SS entry
3.6.2.4. Example Modify Transec Key
The following screen shows and example for updating a Transec key in the base station. The key
is a 256 bit hexadecimal value. User must enter a new value in the ‘Load Key’ entry box. Then
the user must click on the ‘Load Now” Button.
Figure 3-8 Example Modify Transec Key
Once the user click on the ‘Load Now’ button the Transec key will be updated.
Figure 3-9 Example Modify Transec Key Result
In order for the Transec Key to be saved to the database for future use, the user must select the
‘Save Settings’ Button on the left menu (not shown in picture above, refer to 3.6.15.1 Save
Settings Button).
3.6.2.5. Generate Bridging Start Script Example
Bridging is the default mode for operating the units. The Generate Bridging Start Script section
of the admin page allows for configuration of the start script. Once the configuration is set by
selecting the Generate Script button the unit must be rebooted or power cycled for the
configuration to take effect. In this example below depicts new BS start script with an IPv4
address of 10.1.100.1.