User's Guide

Form #: OP_01_TM
Title: Aeronix Data Links – EDL Nano Products User Guide
Document Number: AE301628-001
Revision: B Date: 3 October 2019
Aeronix Proprietary
53
Table 3-12. Base Station Radio Control
Field/Control
Description
to be configured for the same
channelization.
 Channelization Selection – Allows the
selection of the channelization. Current
choices are 3.5 MHz, 7 MHz, and 14 MHz
for OFDM s/w and 14Mhz for GMSK s/w
 Set Button – Changes the current
channelization of the base station to the
new value selected.
Note: Selecting a frequency outside of the
ISM band (2400 – 2483.5MHz) voids the
FCC Part 15.247 Certification.
6
Power Values
Allows the user to adjust the transmit power of the
radio.
 BS Estimated EIRP - Displays the
estimated EIRP of the base station based
upon user configured gains and loss
values. PA Gain + Antenna Gain –
External Tx Cable Loss – Antennal Cable
Loss – Internal Tx Loss.
6A
Power output mode
OFDM
 High Power – radios TX power is
calibrated to a higher power that still has a
good enough EVM to maintain the QAM16
modulations. The QAM64 modulations will
be disabled, if user re-enables them there
is no guarantee the signal quality level will
sustain QAM64
 High Data – radios TX power will be set to
a power level who’s EVM will sustain the
QAM64 modulations. This power may be
lower to maintain the higher EVMs
required by QAM64 modulations.
GMSK
 High Power – radios TX power is
calibrated to an output power of 35 dBm
while still remaining within our GMSK
mask.
 High Data – radios TX power will be set to
a power level of 30 dBm while remaining
within our GMSK mask.
Note: Selecting the high power mode voids
the FCC Part 15.247 Certification.