User's Manual

10 | Location Receiver Installation
2 dBi Omni-directional Dipole Rubber Antenna - Hankook TB2400S
•
•
Vertical polarization
Antenna length: 6.7” (170mm)
Note
Indoor cables for antennas are of type RF Coaxial Cable RG316 SMA(RP)-NT.
These are available in the following lengths: ½ m, 1m, 2m, and 3m.
Location Receiver Installation
Connecting to the Power Source
The Location Receivers can be powered externally or over the Ethernet
network using a standard 802.3af power injector.
To power a Location Receiver using Power over Ethernet:
1. Plug the CAT5 cable to the Location Receiver.
2. Plug the cable into the power supply device (e.g. PoE switch).
3. Check that the green power LED is on.
To power the Location Receiver from an external power supply:
1. Connect the CAT5 cable to the Location Receiver.
2. Connect the CAT5 cable to the hub or switch.
3. Connect the power cable to the Location Receiver.
4. Plug in the power supply cable to a standard 110-240V AC outlet.
5. Check that the green power LED is on.