User's Manual

EX3300 Series Exciter Installation & Configuration Guide
Replacing a Malfunctioning Exciter 21
Figure 5: Customized EX3300 Serial Cable for GOJO LTX and TFX Dispensers (CAB-3300-
LTX)
Replacing a Malfunctioning Exciter
If an embedded EX3300 Exciter is identified as malfunctioning or damaged it
can be replaced on site by performing the following tasks:
Open the dispenser and remove the EX3300 Exciter. 1.
Using the Exciter serial configuration cable and the Exciter Manager Tool 2.
configure the Exciter ID of the replacement Exciter, with the same ID as
the malfunctioning/damaged Exciter. It is recommended to annotate the
new ID on the Exciter housing for future needs.
Configure the range of the Exciter (if required). 3.
Install the replacement EX3300 Exciter in the Dispenser. 4.
Test the Exciter. 5.