User's Manual

EX3300 Series Exciter Installation & Configuration Guide
Installing the Exciters 7
Installing the Exciters
This chapter describes how to install the EX3300 Exciters in the different
dispenser models. Each dispenser model is compatible with a specific EX3300
Exciter model.
Note
The EX-3300 Exciter must only be installed in the EcoLab Hand Sanitizer
Dispenser or the GoJo Hand Sanitizer Dispensers.
Installing the EX3300 Exciter in an EcoLab Next Gen Dispenser
To open the dispenser:
Press the large button situated on the bottom of the dispenser. This 1.
releases the (bottom) hinged dispenser outer casing from the back panel,
allowing it to open forwards.
Note
Approach the dispenser from the side, being careful not to activate the
dispensing mechanism.
To Install the EX3300 Exciter:
Remove the tape from the double sided Velcro on the back of the Exciter 1.
casing.
Align the positioning nodes on the Exciter casing with the holes on the 2.
dispenser's front panel and fix the Exciter in place.