User's Manual

AeroScout EX5100 Exciter
Chaining Exciters 16
9. The Termination Switch (item 5 in Figure 4) of the master and the last slave in
the chain should be set to On (o-o).
On the other slaves, it should be set to Off ( -o o-).
10. The Master/Slave configuration is done using System Manager 4.3 or higher. If
you are using an older version of System Manager, the master-slave
configuration is done using the Slave Exciter Configuration Tool (SECT). See
Appendix A. Slave Exciter Configuration Tool.
The slaves will inherit the master's ID and its LF configurations aside from the
transmission range.
Figure 8: Slave configuration in System Manager