User's Manual

AeroScout EX5100 Exciter
Appendix A. Slave Exciter Configuration Tool 29
Figure 19: Activation – Multiple Exciters
3. In the List of Exciters IP addresses type the IP address of the Exciters to
configure.
You can separate the IP addresses with any of the following characters: commas,
spaces, semicolons (;), tabs.
4. To check whether the Exciters are in working order, click the Check Status
button.
The tool returns a report specifying the Exciters that have responded and those
that have not responded. For the latter, the type of failure. The report also lists
the illegal IP addresses, if any.
5. If you wish to modify the Exciters’ range, select the Use new info radio button
and type the value in the Range field. All of the Exciters included in the
operation will be set to the range you entered.
The phase should not be changed unless instructed so by AeroScout Support.
If you want to keep the values already configured (using AeroScout System
Manager or AeroScout Network Exciter Manager), select the Use preconfigured
phase and range.
6. Finally, to configure the Exciters as slaves, click the Configure to Slave button.
The tool returns a report specifying the Exciters that have been configured and
those that have not been configured. In the latter case, the type of failure is
indicated. The report also lists the illegal IP addresses, if any.