Configuration Guide
Table Of Contents
- Introduction
- Exciter Applications and Industry Examples
- Exciter Features
- LED Status Indicators
- Exciter Connector Panel
- Wiring the Exciter
- LF Coverage
- Network and Power Connections
- Chaining EX5210R Exciters
- DHCP
- Resetting the Exciter IP Address
- Mounting the Exciter
- Appendix A: Exciter and Accessories
- Appendix B: Exciter Specifications
EX5210R Exciter Installation & Configuration Guide
21
Configurations for Engine 5.3 and above
1. Connect the Chained Exciter directly to the network via the LAN port.
2. In the General Settings tab, under Network Configuration, make sure
Connected to Network is checked.
3. Select the LF General tab and configure the following parameters:
• Under General LF Parameters select LF Chaining as Chained.
4. Select the Internal LF tab and configure the following:
• Select the desired Transmission Range of the Chained Exciter so that
the LF coverage is sufficient and some overlap exists between the
chained Exciters.
5. Select the General Settings tab again and perform the following:
• Under Functional Modules make sure that Enable Internal LF is
checked.
• Under Network Configuration uncheck Connected to Network.