Configuration Guide
Table Of Contents
- Introduction
- Exciter Applications and Industry Examples
- Exciter Features
- LED Status Indicators
- Exciter Connector Panel
- Wiring the Exciter
- LF Coverage
- Network and Power Connections
- Chaining EX5210R Exciters
- DHCP
- Resetting the Exciter IP Address
- Mounting the Exciter
- Appendix A: Exciter and Accessories
- Appendix B: Exciter Specifications
EX5210R Exciter Installation & Configuration Guide
8
Message Programming Functions
The Exciter can store messages on the Tag for subsequent transmission. The
stored messages can subsequently be triggered by other Exciters, enabling
sophisticated process control functions.
The Exciter can trigger a Tag to:
Transmit up to 15 bytes of data sent to it by the Exciter
Transmit one of 15 pre-stored (customer-created) messages
Store up to 15 bytes of data sent to it by the Exciter
Network Connectivity
When connected to the network, the Exciter can be remotely programmed,
monitored, and its firmware can be updated via the AeroScout Engine. The
Exciter can also work in an offline mode, thus eliminating the need for a
physical network connection. In the offline mode, however, remote
configuration and monitoring is not available.
Chaining
In an area where the required low frequency (LF) coverage exceeds the capacity
of one Exciter, the Exciter can be chained to another Exciter for complete and
precise coverage.