User's Manual
Table Of Contents
- Introduction
- EX5500 Controller Applications and Industry Examples
- EX5500 Controller Features
- EX5500 LED Status Indicators
- Network and Power Connections to EX5500
- Chaining the EX5500 Controllers
- Resetting the EX5500 Controller IP Address
- Configuring the EX5500 Controller
- Configuring the Controller via Cisco MSE
- Mounting the Controller and External LF Antenna
- Mounting the Controller or External LF using the Exciter Mounting Clip
- EX5500 and Accessories Model Numbers
- EX5500 Specifications
EX5500 Controller Installation & Configuration Guide
21
Controller Reaction
a. Enter the Timeout in seconds.
6. Set a Mask around the EX5500 Controller.
7. If you wish to change IP settings (IP, subnet, gateway, or ports), you can do so
by right-clicking on the Exciter icon and selecting IP Settings.
8. Check the EX5500 Controller status by right-clicking the Exciter icon and
selecting Status.
9. In the Status dialog box verify the firmware version. (DSP and Second Boot) are
compatible with the current version of Stanley Healthcare Engine and the
Exciter hardware version.
Consult Stanley Healthcare Support for appropriate firmware versions.
10. Position and mount each EX5500 Controller in the site according to the site
survey recommendations.
11. Align the EX5500 Controller position according to the required coverage area.
12. If you wish to define an EX5500 Controller as an offline Exciter, you must define
the Controller as disconnected from network in the Exciter Properties dialog
box, approve the settings and then disconnect the Exciter from the network.
For more information, refer to the AeroScout Engine User Guide.