User's Manual Part 1

User and Deployment Guide
24
Rear Recessed Connection Panel
The back of the Controller contains a recessed connection panel for all EX5700
Controller connections including power and peripheral equipment (e.g., Indoor
Keypad, Outdoor Keypad, etc.) including:
x Cable Ports
x Reset Hole
x Wire Terminal Block
Cable Ports
LAN / PoE: RJ-45 connector. In a configuration with a physical Ethernet cable
connection to the LAN, the network cable is attached here.
Permanent connection to a wired network is not mandatory.
Note
PoE is currently not supported.
The EX5700 supports 100 Mb full-duplex communications. The Network Switch
must be configured to Auto Negotiation mode when connecting the Controller
to the Network Switch, in order to use the 100 Mb communications.
Note
When an Ethernet device is set to 100Mb/Full Duplex fixed, as in the
EX5700, and the switch port is set to auto-negotiate, then according to
the 802.3 standard, the communication from the switch side will be set to
100Mb/Half duplex.
24-48 VDC: Accepts an input voltage of 24-48 VDC. This is a standard 5 mm
(outer) 2.5 mm (internal) jack connector for direct power supply. The power
adapter is not supplied with the Controller and can be purchased separately.