User's Guide

Hardware Features

Speaker

The speaker allows the Monitor alarm (and recorded

message, if added) to be audible.

Reset Button

The Reset Button is used to display the monitor’s status

without disrupting the monitoring session, to cancel audible

alarms, and to put the monitor into Hold or Suspend Mode.

Hold or Suspend Mode is used

to suspend patient/resident monitoring to allow staff to move the

patient/resident temporarily (adjust bedding, trip to the toilet, etc.)

Button press duration variations are as follows:

• A single press is used to hear the monitor’s Delay status or cancel any

audible alarms.

• Two presses are used to set the delay. See “Setting the Alert

Delay” on page 5.

• A 3 second press is used to place the monitor in Hold Mode for

30 seconds. See “Hold Mode (30 Seconds)” on page 23.

• A 5 second press is used to place the monitor in Suspend Mode for 2

minutes (120 seconds). See “Suspend Mode (2 Minutes)” on page 24.

Front Panel Status Indicators

The front panel Status Indicators include the following 3 icons:

• Alert Delay 1s

• Alert Delay 2s

• Low Battery