Aerosoft HUEY X 1.00 manual CONTENTS COPYRIGHTS ..................................................................................................................................................................3 CREDITS..........................................................................................................................................................................4 SYSTEM REQUIREMENTS ....................................................................................................
Aerosoft HUEY X 1.00 manual CHECKLISTS ..................................................................................................................................................................23 INTERIOR CHECK ......................................................................................................................................................23 ENGINE PRE-START ..........................................................................................................................
Aerosoft HUEY X 1.00 manual THE BELL UH-1H (UH-1D) / BELL 205A-1 The Bell UH 1(Bell 205) is without a doubt one of the most famous helicopters. The first versions where produced in 1956 and it is still manufactured today. Bell named it UH-1 Iroquois but it became better known under the Huey nickname. Without a doubt the Vietnam War played an important role in the development and fame of the aircraft. For the first time infantry were highly mobile and could operate anywhere in the range of the Huey.
Aerosoft HUEY X 1.
Aerosoft HUEY X 1.00 manual INSTALLATION AND REMOVAL This product uses the Aerosoft Installer and Launcher combination. That means that you will have to activate the product online after installing it. This is very simple -- however, if you need assistance check Appendix A where it is explained step-by-step. After installing it can help to defragment your hard disk (unless it is a SSD drive that should not be defragmented).
Aerosoft HUEY X 1.00 manual Retreating blade stall Control effectiveness depending on hydraulics pressure The Huey has been tested by four pilots who in total have thousands of hours at the controls of this helicopter. They assure us the behavior in flight is very accurate. Please note that vortex ring state (VRS) is NOT included because the Huey does not suffer from this dangerous condition.
Aerosoft HUEY X 1.00 manual FLYING THE HUEY As helicopters go the Huey is one of the easiest to fly. It is very stable and not as nervous on controls as many other helicopters. As the helicopter has been manufactured for many decades and has been improved as time went on all the nasty behavior has been corrected. It is very predictable in all conditions. To get acquainted with the Huey we advise you to position the helicopter on a wide long runway in perfect weather conditions (no wind) with full tanks.
Aerosoft HUEY X 1.00 manual SYSTEMS The UH-1 has simple systems compared to modern helicopters. This makes it easy to maintain and highly reliable. CAUTION SYSTEM The caution panel will have lit sections when systems are not working correctly. This can be because they are not switched on (for example when the engine is not running) or because there is a failure. Any lit indication will also illuminate the MASTER CAUTION light.
Aerosoft HUEY X 1.00 manual LIGHTING The internal lighting system consists of overhead dome lights that can be white or green and panel lighting in green. In flight only the panel lights are used. Note that the white dome lights are useful if you find the whole cockpit too dark, even during daylight hours. Do note that like many military cockpit the Huey panels are dark and offer little contrast.
Aerosoft HUEY X 1.
Aerosoft HUEY X 1.00 manual ENGINE AND POWER TRAIN SYSTEMS The 1,400 shp Lycoming T-53-L-13 turboshaft engine is made up with a 5-stage axial compressor and a 1-stage centrifugal compressor. Although it is not a modern engine it is light, powerful and highly reliable. In many UH-1H’s it is limited to a lower maximum power output to reduce wear on the other components. The engine is connected by the main drive shaft to the transmission.
Aerosoft HUEY X 1.00 manual GYRO The C-2G compass panel allows you to put the gyro in DG and MAG mode and the aligning of the gyro compass. The system is normally in MAG mode where the compass corrects the drift of the gyro. The DG mode is only available as backup. AVIONICS TRANSPONDER The IFF/ Transponder will respond to enquiries from the traffic control systems in civil mode and will avoid being fired on by friendly forces in military mode.
Aerosoft HUEY X 1.00 manual PANELS AND GAUGES In the virtual cockpit the [a] key cycles through the diverse views (note there is no 2D panel) Pilot View Center Console (front) Center Console (aft) Overhead Panel (front) Overhead Panel (aft) Copilot View Observer View State Selector panel All controls, knobs and switches can be operated with the mouse using the following logic: When a switch can only be toggled this is done with the left mouse button.
Aerosoft HUEY X 1.00 manual RIGHT MAIN PANEL 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15.
Aerosoft HUEY X 1.00 manual LEFT MAIN PANEL 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16.
Aerosoft HUEY X 1.00 manual CENTER CONSOLE AFT 1. 2. 3. 4. 5. 6. 7. ADF frequency setting ADF power knob (left click) 100 kHz setting knob (mouse wheel) 10 kHz setting knob (mouse wheel) 1 kHz setting knob with 0.
Aerosoft HUEY X 1.00 manual CENTER CONSOLE FRONT 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14.
Aerosoft HUEY X 1.00 manual ENGINE INSTRUMENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16.
Aerosoft HUEY X 1.00 manual OVERHEAD PANEL 1. 2. 3. 4. Dome lights (left / right click) Pitot heat (left click) Instrument lights (left click) Position (NAV) lights STEADY / OFF / FLASH) (left / right click) 5. Position (NAV) lights BRIGHT / DIM (NVG) (left click) 6. Anti-collision lights (strobes and beacon) (left click) 7. Wiper select switch PILOT / BOTH / CO-PILOT (left / right click) 8. Wiper speed selector (left / right click) 9. Cargo release arming (left click) 10.
Aerosoft HUEY X 1.00 manual CIRCUIT BREAKER PANE L There are four circuitbreakers operational because they are used in the checklists. 1. 2. 3. 4.
Aerosoft HUEY X 1.
Aerosoft HUEY X 1.00 manual OPERATING LIMITATION S TYPE OF OPERATION The helicopter is certified for day and night operations in known non-icing conditions. The equipment in the models we provide allows day and night IFR operations AMBIENT AIR TEMPERATURE LIMITATIONS The maximum sea level ambient temperature for operations is +53°C. The minimum sea level ambient temperature for operations is -52°C. Engine de-icing and pitot heat has to be turned on at temperatures below 5°C for flights in visible moisture.
Aerosoft HUEY X 1.00 manual CHECKLISTS Please note that the checklists are also available in formats suitable for tablets and smartphones. INTERIOR CHECK 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. 28. 29. 30. 31. 32. 33. 34. 35. 36. 37. Flight Controls ........................................ FREE HYD EMER OVER sw ............................... CHECK CLOSED COVER SEARCH & LDG lt sw ............................... OFF Avionics equipment .............
Aerosoft HUEY X 1.00 manual ENGINE PRE -START 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. BAT sw .................................................... ON ICS control panel .................................... CHECK Engine vibration indicator check ............ TEST BAT-HOT lt .............................................. TEST FIRE detector lt ....................................... TEST CARGO REL ARMED lt ............................. TEST Torque meter indicator ..........................
Aerosoft HUEY X 1.00 manual 15. FUEL BOOST pump check ....................... PERFORM 16. DE-ICE .................................................... PERFORM 17. DE-ICE sw ................................................ ON EGT ......................................................... CHECK INCREASE 18. DE-ICE sw ................................................ OFF EGT ......................................................... CHECK DECREASE 19. Engine / Transmission gauges ................ ALL NORMAL 20.
Aerosoft HUEY X 1.00 manual AFTER TAKEOFF / CRUISE 1. 2. 3. 4. 5. 6. 7. Power and trim ....................................... SET FOR CRUISE FORCE TRIM sw ...................................... ON Attitude indicator ................................... SET Altimeter ................................................ CHECK OAT ......................................................... CHECK PITOT HTR / DE-ICE ................................. AS REQUIRED Fuel consumption ...................................
Aerosoft HUEY X 1.00 manual APPENDIX A: THE AERO SOFT INSTALLER AND LAUNCHER The new installer and launcher system has advantages for Aerosoft (it protects our copyrights better) and for the customers (makes it easier to see what is installed and which updates are available. Using the new system is simple and only adds a few steps to what was used before. However, there are four things that you have to keep in mind.
Aerosoft HUEY X 1.00 manual Now you have to accept the license agreement. Easy to click [I accept....] but you might like to read the text at least once, okay? Enter your email address and the serial code we have sent you.
Aerosoft HUEY X 1.00 manual A few screens that tell you what will happen. Click [Next] unless you see an obvious issue. One more...
Aerosoft HUEY X 1.00 manual The files are now installed. It will take a few seconds. And you're done. Click [Finish] to close the installation part of getting the software in FSX. Now Aerosoft Launcher will start and you will see this.
Aerosoft HUEY X 1.00 manual Click on the [Sceneries] to open that section of the product tree. And there is the product we have just installed. By clicking on the [Activate] button the launcher will activate the software.
Aerosoft HUEY X 1.00 manual Select the download shop you used, enter the email address used when buying and the serial code and click [Online activation]. You will see the program contact the server and do its work. Note that only appropriate information is sent. Product code, email address etc. Eh voila, the product shows in green and you can now start FS to start enjoying the product.