Product Manual

No. 31071 - 10/12
FAULT-FINDER® CLEANER (GROUP 1)
PRODUCT NUMBERS: 1071 7.5-OZ. NET WT. AEROSOL
I. GENERAL DESCRIPTION
Description: This Fault-Finder® Cleaner contains no
chlorine or sulfur bearing solvents. Group 1 was developed
specically for testing materials where halogenated safety
solvents are not permitted.
Benets: Conforms to MIL-I-25135. Meets residual
chlorine and sulfur requirements of NAVSHIPS 250-1500
and MIL STD 271 (sec. 5.3.1). Provides a portable and
accurate inspection system. It's use is very versatile and
simple to use and affords immediate results.
Uses: Use to clean metals, glass and plastic before
applying penetrant.
Application: Pre-clean parts or surface with # 1071
Cleaner. Apply a heavy wet lm and let soak. Wipe
clean and repeat as necessary. Dry thoroughly before
using penetrant. Spray No. 1072 Penetrant on area and
allow to soak, up to 20 minutes. Remove while still damp.
Wet a cloth with No. 1071 Cleaner and wipe surface to
remove surface penetrant. Excess penetrant may distort
test indications. Shake No. 1073 Developer thoroughly
until agitator ball rattle. Apply developer holding can 8" to
12" from surface. Developer may be applied immediately
after excess penetrant has been removed, but not longer
than 10 minutes prior to visual inspection. Cracks, pores,
and faults will now be outlined in RED. Invert can and
spray momentarily to clean spray head.
Limitations: Please refer to the Material Safety Data
Sheet for specic information on material hazards, etc.
Packaging:
Aerosol: Cans (211x413) 7.5 oz. net wt. (213g) 10.4 . oz. (306ml)
12 cans/case 10 lbs. (4.5kg) 0.18 CF (0.005 CM)
Product Data Sheet
Aervoe Industries, Inc.
P.O. Box 485, Gardnerville, NV 89410
[phone] Phone • [phone] Fax • [phone] Customer Service
www.aervoe.com • [e-mail]