Product Manual

No. 10630 - 05/16
HI-TEMP PAINT
PRODUCT NUMBERS:
I. GENERAL DESCRIPTION
Description: Zynolyte® Hi-Temp Paint is a ame resistant
and heat resistant coating uniquely formulated to produce
a lasting nish that is resistant to surface temperatures
reaching up to 1,200°F (649°C). It is expressly designed
for use on metal surfaces subject to extreme heat.
Benets: Best used where high temperature protection is
vital. Use on interior and exterior applications. Fast drying.
Once cured, this product is extremely tough, offering a
hardened surface coating resistant to corrosion and pitting
of the surface it covers. Will not chip off or peel away.
Will not discolor or chalk. Offers excellent resistance to
gasoline, rust, salt sprays, oils, greases, humidity and
temperatures up to 1,200°F (649°C).
Application: May be used on all exposed metal surfaces,
particularly where extreme heat resistance is required,
such as engine manifolds, mufers, incinerators, space
heaters, outside of barbecues, replaces, etc.
Directions: For best results, apply only enough paint
to provide complete coverage of the substrate. Apply
only to surfaces between 50° and 95°F (10° and 35°C).
All surfaces must be clean, dry, and free of all dust dirt,
grease, wax, mildew, or other contaminants that would
adversely affect paint adhesion. Extremely slick, glossy
surfaces should be lightly sanded. Areas with exposed
rust should be scraped clean with a scraper or wire
brush. Cover adjacent areas to protect from spray mist.
To achieve the highest temperature protection and to
thoroughly cure the coating, allow coating to air-dry for
30 minutes then gradually increase the temperature
between 450° to 650°F (232° to 343°C), two to three
times, allowing it to cool to room temperature between
rings. While curing, smoke will be emitted from the lm
therefore, good ventilation of the work area is required.
Shake can for at least one minute after rattle of agitator
ball is heard, and intermittently during use. Hold can 8 to
12 inches from surface to be coated, and press sprayhead
rmly. Use steady, even strokes while spraying. After
spraying, turn can upside down and press spray button
for approximately two seconds to clear paint from valve.
Limitations: Please refer to the Safety Data Sheets for
specic information on material hazards, etc. Do not apply
at temperatures less than 40°F (4°C).
Packaging:
Aerosol: Cans (211x604) 11 oz. net wt. (312 g) 13.1 . oz. (387 ml)
Case (6/case): 7 lbs. (3.18 kg) 0.44 CF (0.012 CM)
Product Data Sheet
Aervoe Industries, Inc.
P.O. Box 485, Gardnerville, NV 89410
[phone] Phone • [phone] Fax • [phone] Customer Service
www.aervoe.com • [e-mail]
AEROSOL VOC/CARB MIR < 80% / 1.85
Z630 - ALUMINUM
Z635 - BLACK
Z642 - MACHINERY GRAY
Z645 - WHITE