User's Guide

Getting Started
POWER ON & OFF
To power on the glasses, open the case’s lid
and wait for the power-on sound prompt before
removing the glasses from the case.
To power off the glasses, place the glasses
back inside the charging case and close the lid.
The glasses will power off if it’s been idle for over
an hour. To power on the glasses without placing
them inside the case, wear the glasses and long-
press both touch controls for 5 seconds.
CONNECT
To connect to a new device, long press either
sides of the touch controls for 5 seconds until
you hear the voice prompt “Bluetooth pairing,”
then activate your device’s Bluetooth and
connect to “Aether Eyewear.” If you hear the
prompt “Bluetooth pairing failed,” repeat the
procedure above again.
To force disconnect the current device and
connect to a new device, long press either sides
of the touch controls for 5 seconds.
CHARGE
To charge the glasses, place them back inside
the charging case by folding the left temple
before the right temple. Once placed inside,
make sure the glasses are resting flat inside the
case and that the charging indicator light inside
the case is showing either orange or green.
To recharge the case, plug the provided USB-C
charging cable into the back of the case and
make sure the indicator light next to the USB-C
socket shows either orange or green.
SPEAKERS
TOUCH
CONTROL
MICROPHONE