AEV Xtreme II Digital Audio Processor AEV Xtreme II Digital Broadcast Audio Processor AEV Broadcast Srl – via della Tecnica 33 – 40050 Argelato (BO) Italy Web site www.aev.eu e-mail info@aev.
AEV Xtreme II Digital Audio Processor Guarantee The equipment is warranted for a period of 2 years from the date of invoice (ex-works). The warranty does not cover faults provoked by carelessness, natural causes and parts subject to wear. In addition, the cost of shipment is not covered. The warranty will be voided if the equipment is mishandled. Technical Support If you require technical support, contact AEV SERVICE giving a clear and concise account of your speciic problem.
AEV Xtreme II Digital Audio Processor - Keep the equipment away from drops of water or sprinkling systems. - Never use the equipment near high heat sources or explosive material. - Do not introduce any extraneous matter into the equipment. - Do not allow children or untrained people to use the equipment. • Before cleaning or servicing the equipment outside, disconnect it from the supply and wait at least 2 seconds before working on it, as recommended by current safety regulations.
AEV Xtreme II Digital Audio Processor Contents PRECAUTIONS.......................................................... 2 Contenents .......................................................... 4 Sec. 1 The Xtreme audio processor ................................... 5 Sec. 1-1 Full control of peak modulation ............................ 5 Sec. 1-2 Programmability ............................................ 5 Sec. 1-3 Input/output configurations ................................ 5 Sec.
AEV Xtreme II Digital Audio Processor Sec. 1 The Xtreme audio processor The Audio Xtreme II processor is a complete audio signal processing system for AM, FM and TV transmissions. The sound quality defines the station’s image and professionalism. The importance of the AUDIO PROCESSOR is therefore clear. The wholly digital technology with which Xtreme II was built means that the results obtained can IN NO WAY BE COMPARED with those of any other traditional processor.
AEV Xtreme II Digital Audio Processor Sec. 1-4-1 Analogue inputs/outputs The analogue inputs are installed on two XLR female connectors, located on the rear panel. The input is ≥10 KΩ high impedance, and the inputs accept signals up to +12dBu. The analogue outputs are provided with two XLR male connectors, located on the rear panel. The outputs can pilot loads of ≥10 KΩ. Sec. 1-4-2 Digital inputs/outputs The digital input is provided with an XLR female connector, located on the rear panel.
AEV Xtreme II Digital Audio Processor The display may be difficult to understand at power-up, therefore, set the contrast level (see the appropriate section) Sec. 3 Input/Output connections When connecting inputs/outputs, you are recommended to use a good quality, well shielded, soft cable. 0 0 Sec. 3-4 Remote control Xtreme II can be remotely controlled via an RS-232 standard serial port – this enables you to control it via both PC and modem.
AEV Xtreme II Digital Audio Processor By pressing Jog, you can select “Recall Preset”, then choose one of the 18 preset curves At the end of the selection, return to Home menu by means of the “Back” option. AEV Broadcast Srl – via della Tecnica 33 – 40050 Argelato (BO) Italy Web site www.aev.eu e-mail info@aev.
AEV Xtreme II Digital Audio Processor Sec. 4-1 Pre-enphasis Then select Pre-emphasis and choose Change option. By means of the Jog you can scroll the available options: OFF, 50µS (European standard) and 75µS (USA standard). At the end of the selection, return to Home initial menu. Sec. 4-2 Adjusting the input level Play a piece of music ( CD ) with good dynamics and a rich sound. Adjust the mixer to obtain 0dB indication on the instruments.
AEV Xtreme II Digital Audio Processor Select Input Level and choose Change option. Now, the graphic display of the input level is available. This can be amplified or reduced of 12 dBu. By means of the Jog select a gain in order to have the processor operate around 0 dBm. At the end of the setting, return to Home initial menu. Sec. 4-3 Adjusting MPX coder parameters May we remind you again that any other pre-enphasis on your transmission chain must be disabled as it is generated by Xtreme II.
AEV Xtreme II Digital Audio Processor Below you will find the parameters that may be changed: PARAMETER SELECTABLE VALUES Configuratuon Left Right LR OFF - L OFF - R OFF - LR ON Mode STEREO - MONO Pilot Level OFF -28dB -18.4dB Pilot Phase -15° ÷ +15° Composite Clipper OFF - ON Out 1 Level 0 ÷ +12dBu Out 2 Config MPX - SYNC Out 2 Level 0 ÷ +12dBu SCA Input 0 ÷ -14dBu RDS Input 0 ÷ -14dBu (without RDS coder) -31.5 ÷ -17.
AEV Xtreme II Digital Audio Processor Select the parameter to be changed and carry out the correct set-up by means of the Jog. If you are varying a parameter, but you wish to return to the previously set value, a “X” is shown on the right of the bargraph which not only stresses the control used, but it also goes off if the set value corresponds to the parameter value before any change. AEV Broadcast Srl – via della Tecnica 33 – 40050 Argelato (BO) Italy Web site www.aev.eu e-mail info@aev.
AEV Xtreme II Digital Audio Processor Sec. 4-4 System menu options System menu enables following set-up PARAMETER SELECTABLE VALUES Operate-ByPass OPERATE - BYPASS Lenguage Select. ITALIANO - ENGLISH Time & Date DAY MONTH YEAR HOURS MINUTES SECONDS Contrast 0 ÷ 16 RS232 Selection XTREME - RDS Default Preset ATTENTION.
AEV Xtreme II Digital Audio Processor Sec. 5 Edit Preset menu Through the selection of Process menu, recall the option Edit Preset.
AEV Xtreme II Digital Audio Processor Sec. 5-7 30Hz Hpf Filter A filter which eliminates the “rumble” typical of turntables and feedback from speakers into the microphone. We advise you to leave this ON Sec. 5-8 Voice Bass Boost Xtreme II is able to recognise the voice from the rest of the program and, thanks to this control, it activates a pleasant full bodied, thrusting effect that is great to listen to..
AEV Xtreme II Digital Audio Processor The sound is more or less amplified to reach a 75KHz maximum deviation 0.0 (the original process sound) 5.0 (an exasperated sound at the limit of the first distortion) We recommend from 0.0 to 1.0 max Sec. 5-17 Downward Expander The noise (ground noise) reducer to be activated if using many tape supports or if the sources going on the air carry ground noise (links, telephones, etc.).
AEV Xtreme II Digital Audio Processor Sec. 7-2 Sample connection Remote RDS AEV Broadcast Srl – via della Tecnica 33 – 40050 Argelato (BO) Italy Web site www.aev.eu e-mail info@aev.
AEV Xtreme II Digital Audio Processor Sez. 7-3 Sample connection Remote Sez. 7-4 Sample connection Analog & AES/EBU OUTPUT 1 = GROUND 2 = INPHASE 3 = RETURN INPUT 1 = GROUND 2 = INPHASE 3 = RETURN Sec.
AEV Xtreme II Digital Audio Processor ANALOG AUDIO OUTPUT Configuration Left and Right. Flat or pre-emphasized (50µS – 75µS) Impedance 30 Ohm electronically balanced and floating Minimum load impedance 600 Ohm Maximum output level +12 dBu into 600 ohm load Connector XLR-type, male, EMI suppressed Pin 1 Chassis Pin 2 & 3 electronically balanced, floating and symmetrical STEREO GENERATOR Configuration Pilot freq.