Specifications

ACUO 908
AEV Broadcast Srl
Tel. [phone]
Fax [phone]
• Abuse or misuse of the equipment is
The manufacturer declines all responsibility for damage an
use and mishandling.
• Certain basic safety rules must be observed when using electrical equipment, in particular:
Never touch the equipment with wet and/or damp hands or other parts of the body.
- Keep the equipment away
from drops of water or sprinkling systems.
-
Never use the equipment near high heat sources or explosive material.
-
Do not introduce any extraneous matter into the equipment.
-
Do not allow children or untrained people to use the equipment.
• Before clea
ning or servicing the equipment outside, disconnect it from the supply and wait at
least 2 seconds before working on it, as recommended by current safety regulations.
• In the event of faults and/or improper operation, turn off the equipment, shut off the
electrical power and call your dealer.
• Do not attempt to make repairs and/or adjustments when covers/guards or circuit boards are
to be removed.
• Blown fuses inside the power supply indicate that there may be a fault in
itself. The fuse
s must be replaced by qualified
your nearest dealer.
• Call your dealer for any repairs and be certain original spare parts are used.
Failure to observe this rule may adversely affect the safety level of your
• The equipment is to be connected to the mains supply and provided with
efficient earth conductors.
• The electrical wiring must be done in compliance with current electrical codes
“Electrical specification
for domestic b
• When installing, leave a clearance of at least 1 cm around the equipment to
freely.
NOTE. This piece of equipment has been manufactured
workmanship. It must be used
long-term
dependable operation.
The installation must be done in order to be able to guarantee an easy access to the cable of
feeding.
The device of dissection of the equipment is the cable of feeding, so it must be unconnected
from the equi
pment every time it is necessary to do any type of maintenance.
ACUO 908
Serie - AEV ON AIR CON
SOLE
AEV Broadcast Srl
, via della Tecnica 33 –
40050 Argelato (BO) Italy
Fax [phone]
Web site www.aev.eu
3
• Abuse or misuse of the equipment is
extremely dangerous
for people, pets and property.
The manufacturer declines all responsibility for damage an
d injury resulting from
• Certain basic safety rules must be observed when using electrical equipment, in particular:
Never touch the equipment with wet and/or damp hands or other parts of the body.
from drops of water or sprinkling systems.
Never use the equipment near high heat sources or explosive material.
Do not introduce any extraneous matter into the equipment.
Do not allow children or untrained people to use the equipment.
ning or servicing the equipment outside, disconnect it from the supply and wait at
least 2 seconds before working on it, as recommended by current safety regulations.
• In the event of faults and/or improper operation, turn off the equipment, shut off the
electrical power and call your dealer.
• Do not attempt to make repairs and/or adjustments when covers/guards or circuit boards are
• Blown fuses inside the power supply indicate that there may be a fault in
s must be replaced by qualified
and authorised
persons. It is advisable to call
• Call your dealer for any repairs and be certain original spare parts are used.
Failure to observe this rule may adversely affect the safety level of your
• The equipment is to be connected to the mains supply and provided with
• The electrical wiring must be done in compliance with current electrical codes
for domestic b
uildings”.
• When installing, leave a clearance of at least 1 cm around the equipment to
NOTE. This piece of equipment has been manufactured
to the highest standards of
workmanship. It must be used
properly and serviced as recomme
nded to ensure
dependable operation.
The installation must be done in order to be able to guarantee an easy access to the cable of
The device of dissection of the equipment is the cable of feeding, so it must be unconnected
pment every time it is necessary to do any type of maintenance.
SOLE
40050 Argelato (BO) Italy
e-mail [e-mail]
for people, pets and property.
d injury resulting from
improper
• Certain basic safety rules must be observed when using electrical equipment, in particular:
-
Never touch the equipment with wet and/or damp hands or other parts of the body.
ning or servicing the equipment outside, disconnect it from the supply and wait at
least 2 seconds before working on it, as recommended by current safety regulations.
• In the event of faults and/or improper operation, turn off the equipment, shut off the
• Do not attempt to make repairs and/or adjustments when covers/guards or circuit boards are
• Blown fuses inside the power supply indicate that there may be a fault in
the power supply
persons. It is advisable to call
• Call your dealer for any repairs and be certain original spare parts are used.
Failure to observe this rule may adversely affect the safety level of your
equipment.
• The equipment is to be connected to the mains supply and provided with
adequate and
• The electrical wiring must be done in compliance with current electrical codes
CEI 64-8
• When installing, leave a clearance of at least 1 cm around the equipment to
allow air to pass
to the highest standards of
nded to ensure
The installation must be done in order to be able to guarantee an easy access to the cable of
The device of dissection of the equipment is the cable of feeding, so it must be unconnected
pment every time it is necessary to do any type of maintenance.